1. Rotary encoder events can be configured either as relative events
as the legacy code does or as any specified key code, this is
useful on some platform which uses the rotary keys as
KEY_{UP/DOWN/LEFT/RIGHT}
2. Add support for direct keys, the corresponding keycodes for each
direct key can now be specified within the platform data
3. Remove the direct/rotary key detection code from the IRQ handler
to dedicated functions to improve readability
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Introduce pxa27x_keypad_config() for keypad registers configuration
and remove the reg_kpc, reg_kprec from platform data structure
so that configurations of keypad registers can be centralized to a
single function.
It can also be re-used when resuming.
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
1. Introduce the "struct pxa27x_keypad" structure for driver specific
information, such as "struct clk", generated matrix key codes and
so on
2. Use KEY() macro to define matrix keys, instead of original 8x8 map
this makes definition easier with keypad where keys are sparse
3. Keep a generated array in "struct pxa27x_keypad" for fast lookup
4. Separate the matrix scan into a dedicated function for readability
and report only those keys whose state has been changed, instead
of report all states
5. Make use of KPAS to decide the faster path if only one key has been
detected
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The pin configurations will slowly be moved to the board specific code
at initialization thus to make the driver more generic.
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The controller should really be called keypad, and also align
the naming of functions and structures to use "pxa27x_keypad"
as prefix, instead of "pxakbd".
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
If firmware does not implement AUX_LOOP comand in 32 bit mode it
is unlikely to implement it in 64 bit mode. Same goes for active
multiplexing. See:
http://bugzilla.kernel.org/show_bug.cgi?id=9664
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The Acer Aspire 9110 series also requires the Dritek quirk to enable the
extra scancodes.
Signed-off-by: Carlos Corbacho <carlos@strangeworlds.co.uk>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
This patch adds a very simple input power event to APM user suspend
event bridge. Its currently only works for the systems using the
emulated APM driver but could easily be extended to work with anything
with a true APM BIOS too.
This covers a standard embedded system need which is to suspend when the
user presses a suspend button. It leaves options open to system
integrators to ignore (or unload) this code and implement their own more
complex event handling system.
Its hidden behind the EMBEDDED Kconfig option since its only likely to
be of use to embedded style systems. It can be built as a module so the
"hardcoded" policy can easily be removed from the kernel at runtime if
desired too.
Signed-off-by: Richard Purdie <rpurdie@rpsys.net>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Cdev field was obsolete and provided only for backward compatibility
since conversion of input core from class devices to regular devices.
It is time to remove it.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
drivers/char/keyboard.c: linux/consolemap.h is included more than once.
Signed-off-by: Francisco Alecrim <francisco.alecrim@indt.org.br>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Some Wistron based laptops need us to explicitly enable the 'Dritek
keyboard extension' to make their extra keys start generating scancodes.
Originally, this was just confined to older laptops, but a few Acer
laptops have turned up in 2007 that also need this again.
Signed-off-by: Carlos Corbacho <carlos@strangeworlds.co.uk>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Add keyboard support on tosa (Sharp Zaurus SL-6000x).
Largely based on patches by Dirk Opfer.
Signed-off-by: Dmitry Baryshkov <dbaryshkov@gmail.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
This driver supports the application buttons on some Fujitsu Lifebook
laptops. It is based on the earlier apanel driver done by Jochen Eisenger,
but with many changes. The original driver used ioctl's and a separate
user space program (see http://apanel.sourceforge.net). This driver hooks
into the input subsystem so that the normal keys act as expected without a
daemon. In addition to buttons, the Mail Led is handled via LEDs class
device.
The driver now supports redefinable keymaps and no longer has to have a DMI
table for all Fujitsu laptops.
I thought about mixing this driver should be integrated into the Fujitsu
laptop extras driver that handles backlight, but rejected the idea because
it wasn't clear if all the Fujitsu laptops supported both.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
This stops the ads7846 driver from using dev->power.power_state; that field is
deprecated (overdue for removal) and the only reason to update it was to make
the /sys/devices/.../power/state files (now removed) work better.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Drop #include <linux/moduleparam.h> in files that also include
linux/module.h, since module.h includes moduleparam.h already.
Signed-off-by: Julia Lawall <julia@diku.dk>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The input example driver uses BTN_0 in the later stages of the
example, so this changes the interrupt routine to match.
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Rounding doesn't matter for the first tick, but we want
succeeding ticks to be aligned on second boundary if poll
interval is large enough.
Also: cancel_rearming_delayed_workqueue is marked as obsolete
in workqueue.h so use cancel_delayed_work_sync.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Acked-by: Arjan van de Ven <arjan@linux.intel.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Drivers should use input_{get|set}_drvdata() instead of accessing
input_dev->provate directly, but since these drivers do not actually
use the data stored there we can simply remove the assignments.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Acked-by: Mauro Carvalho Chehab <mchehab@infradead.org>
RT guys advised me that in their kernels synchronize_sched() will not
work to ensure that all IRQ handlers run to their completion and that
synchronize_irq() should be used instead.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Take dev->event_lock to make sure that we don't race with input_event() and
also force key up event when removing a key from keymap table.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Most of Fn+F? special keys on (at least) the Dell Latitude laptops don't
generate a hardware key release event so the driver has to generate one.
Signed-off-by: Giel de Nijs <giel@caffeinetrip.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The recently added support for Dell Volstro 1400 was causing protocol
synchronization errors on Acer Aspire 5720ZG, fix it.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The lifebook driver may register a second input device, but it never
unregisters it. This fixes that.
Signed-off-by: Andres Salomon <dilinger@debian.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
If we successfully call input_register_device() in psmouse_connect()
but sysfs_create_group() fails, we'll enter the error path without
ever having called input_unregister_device() potentially leaking
memory.
Signed-off-by: Andres Salomon <dilinger@debian.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Fix a buffer overflow in mutli-packet handling code. The overflow can
only happen with eGalax devices and is even there very unlikely (only
non-report packet are affected any only when truncated after the first
byte).
Also changes the mutli-packet handling code not to drop unknown packets,
but rather just drop one byte. This allows synchronizing on report packets
in the data stream. It's required for some egalax devices to work at all.
Also remove the pointless 'flags' member of the device struct and set the
version number to 0.6, plus some minor cleanups.
[akpm@linux-foundation.org: coding-style fixes]
Signed-off-by: Daniel Ritz <daniel.ritz@gmx.ch>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Devices like the HP Integrated Remote Console Virtual Mouse, which are
standard equipment on all Proliant and Integrity servers, produce
absolute coordinates instead of relative coordinates. This is done to
synchronize the position of the mouse cursor on the client desktop
with the mouse cursor position on the server. Mousedev is not
designed to pass those absolute events directly to X, but it can
translate them into relative movements. It currently does this for
tablet like devices and touchpads. This patch merely tells it to also
include a device with ABS_X, ABS_Y, and mouse buttons in its list of
devices to process input for.
This patch enables the mouse pointer to move when using the remote
console.
Signed-off-by: Micah Parrish <micah.parrish@hp.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
input_handle_event() used to pass EV_PWR events to event handlers
but no longer does so in 2.6.23. Modules to trigger power management
events based on input power events exist but rely on the EV_PWR events
being passed to the input event handlers.
Signed-off-by: Richard Purdie <rpurdie@rpsys.net>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
The spitz keyboard driver reports KEY_SUSPEND events but doesn't
register its use of this event in the keybit bitfield, breaking
input events for this key. This patch fixes that by registering
the key in the keybit bitfield.
Signed-off-by: Richard Purdie <rpurdie@rpsys.net>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
This does not make sense and moreover causes build failures
on alpha.
Signed-off-by: Ivan Kokshaysky <ink@jurassic.park.msu.ru>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
This patch fixes the HP Jornada 6xx keyboard default keymap which had some
bad keymap values. This resulted in wrong key being returned when pressed
(for example, key 'y' returned 'r').
Also, while we are at it lets arrange the include files in alphabetical order.
Signed-off-by: Kristoffer Ericson <kristoffer.ericson@gmail.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Currently, gpio_keys.c assumes the GPIOs to be already properly configured;
this patch changes gpio-keys to perform explicit calls to gpio_request() and
gpio_configure_input().
This matches the behaviour of leds-gpio.
Signed-off-by: Herbert Valerio Riedel <hvr@gnu.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
When booting under Microsoft Virtual Machine, the noloop quirk is
needed, otherwise PS/2 mouse is not properly detected.
Reported-by: Lawrence Steeger <vendor@russte.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
We know exactly what IRQ we are using, so synchronize_irq()
suits much better. Plus synchronize_sched() will not work
for us in -rt kernels.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Acked-by: Mattia Dongili <malattia@linux.it>
Properly set up parent on input devices registered by sonypi.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Acked-by: Mattia Dongili <malattia@linux.it>
Properly set up parent on input devices registered by sony-laptop.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Acked-by: Mattia Dongili <malattia@linux.it>
