Some controllers actually check the first byte of the response (most
don't). This byte contains the command opcode for R1/R1b and all 1:s
for other types. The difference must be indicated to the controller
so it knows which reply to expect.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Some hosts need to know that a transfer will be multi-block.
Add a data flag to indicate multiple data block transfers.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
sg_page_malloc should clear the data buffer, not that extent of mem_map.
This fixes Jesper's sg_page_free "Bad page states"
Signed-off-by: Hugh Dickins <hugh@veritas.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
- Clean up a recently introduced spaces vs tabs whitespace problem.
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Move the code that patches bluebird firmware before upload from the
generic code into the cxusb driver itself.
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Michael Krufky <mkrufky@m1k.net>
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Add VIDIOC_LOG_STATUS to the radio device ioctl list.
- Reduce the confusion between modes and standards
- Fix stereo reporting for radio.
- Don't set i2c configuration if the chip doesn't support it.
- Fix reporting of current standard for radio.
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Implemented v4l2 api for sliced vbi data output
to pass WSS data from userspace to the av7110
Signed-off-by: Oliver Endriss <o.endriss@gmx.de>
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Check capabilities for audio settings (volume, balance,
bass, treble, loudness, mute)
- added loudness support
- added missing VIDEO_AUDIO_BALANCE flags for v4l1 compatibility
- do not call msp_any_detect_stereo for non-autoselect chips to
retrieve the current stereo setting: that will temporarily mute
the sound. It is only needed when the stereo mode might be
changed, and for autoselect msp processors that do not periodically
need to update their stereo setting.
- do not wake up the thread if the standard did not change. Prevents
temporary audio drop-out if the standard is set to the same value.
- fix confused stereo detect code where V4L2_TUNER_SUB_STEREO and
V4L2_TUNER_MODE_STEREO values were used incorrectly.
- stereo mode reporting was broken (v4l2 value used to index a
string array expecting v4l1 mode values).
- do not set dsp register 0x30 in the 3410d thread: that register
does not exist for pre-'G' revision msp chips.
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- A new Kconfig option makes the user able to select if the dibusb-mb driver shall claim faulty programmed USB devices which are coming with default Cypress USB IDs.
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Check if in the dvb-usb-device-structure the dvb_pll_desc is set before use.
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Indention for values of several request defines were not TabSized=8.
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Fixes compiling warning on kernel 2.6.15 with the Intel C compiler.
- It said drivers/media/dvb/frontends/bcm3510.c(258):
warning #592: variable "ret" is used before its value is set
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Replace old norm by the v4l2_std_id values.
- Add code to correctly detect the various capabilities of the
various msp chips. It's not yet used, that's going to be the next step.
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- My original settings for this board were incorrect and resulted in
an increased number of signal dropouts. Replace this with the settings
from the Windows driver.
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Add support for the remote control receiver inside the DViCO FusionHDTV
DVB-T Dual Digital, and a keymap for the MCE remote bundled with it.
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Support for DVB reception on the PCI half of the DViCO DVB-T Dual Digital.
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Add support for the USB portion of the DViCO Dual Digital board.
Patch correct "warm" USB IDs into bluebird firmware before download.
Signed-off-by: Chris Pascoe <c.pascoe@itee.uq.edu.au>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Saa7134-core.c saa7134_irq(): Separate GPIO16 and GPIO18 handling. Call
IR-remote-GPIO handler only if the GPIO IRQ is "owned" by it. Added
infrastructure to branch out to a future I2C-IR IRQ handler.
saa7134-core.c saa7134_hwinit2(): Enable only the one GPIO pin and edge to
trigger an IRQ that is wired as keyup/keydown mask. IRQ will only be
generated for an actual key-down event.
saa7134-input.c flyvideo_codes[]: Replace numpad keys with normal ones. Put
meaning to mystery keys. Change some key definitions to have their functions
match their labels better. Fix typos.
saa7134-input.c flydvb_codes[]: Added new table for the larger remote that
comes with the LifeView FlyDVB series.
saa7134-input.c build_key(): In IRQ mode, signal key-down and then key-up
straight in one go.
Signed-off-by: Ricardo Cerqueira <v4l@cerqueira.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
This is a major update to the cyblafb framebuffer driver. Most
of the stuff has been tested in the mm tree.
Main advantages:
============
- vxres > xres support
- ywrap and xpan support
- much faster for almost all modes (e.g. 1280x1024-16bpp
draws more than 41 full screens of text instead of about 25
full screens of text per second on authors Epia 5000)
- module init/exit code fixed
- bugs triggered by console rotation fixed
- lots of minor improvements
- startup modes suitable for high performance scrolling
in all directions
This diff also contains a lot of white space fixes.
No side effects are possible, only one single graphics core is affected.
Signed-off-by: Knut Petersen <Knut_Petersen@t-online.de>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
__rcu_pending() is rather fat and called twice from rcu_pending().
rcu_pending() has multiple callers, and not that small too.
This patch uninlines both of them.
Signed-off-by: Oleg Nesterov <oleg@tv-sign.ru>
Acked-by: Paul E. McKenney <paulmck@us.ibm.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
- Replaces old debug msgs from bt832, tda743d and tda9875 to newer ones
as defined under v4l2-common.h.
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Both AverTV Studio 303 cards, #6 and #36,
use the same remote control programming.
Signed-off-by: George Gazurkoff <gazurkoff@gmail.com>
Signed-off-by: Michael Krufky <mkrufky@m1k.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- There is a bug in the ioctl translations from 32bit userspace
to 64bit kernelspace in do_set_window().
- The video window (vw) should be passed to native_ioctl()
instead of the video clip.
Signed-off-by: Guy Martin <gmsoft@tuxicoman.be>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Add support for LifeView FlyDVB Trio.
- all analog inputs are supported and working, including FM radio
- TO DO: dvb & remote control
Signed-off-by: Peter Missel <peter.missel@onlinehome.de>
Signed-off-by: Michael Krufky <mkrufky@m1k.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- This module is co-authored by Ricardo Cerqueira <v4l@cerqueira.org>.
- Added digital audio support for cx88-based boards that have function
01 enabled. These boards can be identified by having PCI id 1471:8801
or 1471:8811.
- Increased DMA buffer from 512 to 4096 seems to fix audio distortion.
- Existing audio DMA uses conflict with cx88-alsa. Should be disabled when
cx88-alsa module is compiled.
Signed-off-by: Ricardo Cerqueira <v4l@cerqueira.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Fix signed/unsigned bug in brightness handling (set to 0 and 128 was returned).
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Fix signed/unsigned bug in hue handling (set to -127 and 129 was returned).
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Add the fix for the saa7146 64-bit compile warning (again). This time with
comments and checked by Johannes Stezenbach.
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Reverted objectionable fix in saa7146_hlp.c
- Merged in improved dvb 64-bit fixes from Peter Beutner.
Signed-off-by: Peter Beutner <p.beutner@gmx.net>
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Add DViCO Bluebird firmware to dvb_get_firmware script,
for FusionHDTV USB devices.
- Use usb alt setting 0 for EP4 transfer (dvb-t),
- Use usb alt setting 7 for EP2 transfer (atsc)
- Added comment to lgdt330x.c to indicate support for
DViCO FusionHDTV5 USB Gold.
Thanks to: Jeff Lee <JeffLee@dvico.com>
Signed-off-by: Michael Krufky <mkrufky@m1k.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- This property set is for the LG-H064F (FusionHDTV5 USB Gold)
- There may, in the future, be a bluebird device using a different NIM,
so renaming the struct to somehting NIM-specific is appropriate.
Signed-off-by: Michael Krufky <mkrufky@m1k.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Improved recovery from ARM crash and the way a crash is detected.
Minor white space clean-up, debug output fixed.
Signed-off-by: Oliver Endriss <o.endriss@gmx.de>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
- Convert diagnostics over to the new v4l2-common.h macros.
- deprecated tuner_debug option, the new option is debug.
- renamed cx25840_debug to debug.
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@brturbo.com.br>
