1
linux/drivers/gpio/cs5535-gpio.c
Andres Salomon 44658a11f3 cs5535-gpio: handle GPIO regs where higher (clear) bits are set
The default for non-READ_BACK GPIO regs is to have the clear bits set;
this means that our original errata fix was too simplistic.  This
changes it to the following behavior:

 - when setting GPIOs, ignore the higher order bits (they're for
   clearing, we don't need to care about them).

 - when clearing GPIOs, keep all the bits, but unset (via XOR) the
   lower order bit that negates the clear bit that we care about.  That
   is, if we're clearing GPIO 26 (val = 0x04000000), we first XOR what's
   currently in the register with 0x0400 (GPIO 26's SET bit), and then
   OR that with the GPIO 26's CLEAR bit.

Tested-by: Daniel Drake <dsd@laptop.org>
Signed-off-by: Andres Salomon <dilinger@queued.net>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
2010-12-23 15:31:48 -08:00

381 lines
9.6 KiB
C

/*
* AMD CS5535/CS5536 GPIO driver
* Copyright (C) 2006 Advanced Micro Devices, Inc.
* Copyright (C) 2007-2009 Andres Salomon <dilinger@collabora.co.uk>
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of version 2 of the GNU General Public License
* as published by the Free Software Foundation.
*/
#include <linux/kernel.h>
#include <linux/spinlock.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/gpio.h>
#include <linux/io.h>
#include <linux/cs5535.h>
#define DRV_NAME "cs5535-gpio"
#define GPIO_BAR 1
/*
* Some GPIO pins
* 31-29,23 : reserved (always mask out)
* 28 : Power Button
* 26 : PME#
* 22-16 : LPC
* 14,15 : SMBus
* 9,8 : UART1
* 7 : PCI INTB
* 3,4 : UART2/DDC
* 2 : IDE_IRQ0
* 1 : AC_BEEP
* 0 : PCI INTA
*
* If a mask was not specified, allow all except
* reserved and Power Button
*/
#define GPIO_DEFAULT_MASK 0x0F7FFFFF
static ulong mask = GPIO_DEFAULT_MASK;
module_param_named(mask, mask, ulong, 0444);
MODULE_PARM_DESC(mask, "GPIO channel mask.");
static struct cs5535_gpio_chip {
struct gpio_chip chip;
resource_size_t base;
struct pci_dev *pdev;
spinlock_t lock;
} cs5535_gpio_chip;
/*
* The CS5535/CS5536 GPIOs support a number of extra features not defined
* by the gpio_chip API, so these are exported. For a full list of the
* registers, see include/linux/cs5535.h.
*/
static void errata_outl(struct cs5535_gpio_chip *chip, u32 val,
unsigned int reg)
{
unsigned long addr = chip->base + 0x80 + reg;
/*
* According to the CS5536 errata (#36), after suspend
* a write to the high bank GPIO register will clear all
* non-selected bits; the recommended workaround is a
* read-modify-write operation.
*
* Don't apply this errata to the edge status GPIOs, as writing
* to their lower bits will clear them.
*/
if (reg != GPIO_POSITIVE_EDGE_STS && reg != GPIO_NEGATIVE_EDGE_STS) {
if (val & 0xffff)
val |= (inl(addr) & 0xffff); /* ignore the high bits */
else
val |= (inl(addr) ^ (val >> 16));
}
outl(val, addr);
}
static void __cs5535_gpio_set(struct cs5535_gpio_chip *chip, unsigned offset,
unsigned int reg)
{
if (offset < 16)
/* low bank register */
outl(1 << offset, chip->base + reg);
else
/* high bank register */
errata_outl(chip, 1 << (offset - 16), reg);
}
void cs5535_gpio_set(unsigned offset, unsigned int reg)
{
struct cs5535_gpio_chip *chip = &cs5535_gpio_chip;
unsigned long flags;
spin_lock_irqsave(&chip->lock, flags);
__cs5535_gpio_set(chip, offset, reg);
spin_unlock_irqrestore(&chip->lock, flags);
}
EXPORT_SYMBOL_GPL(cs5535_gpio_set);
static void __cs5535_gpio_clear(struct cs5535_gpio_chip *chip, unsigned offset,
unsigned int reg)
{
if (offset < 16)
/* low bank register */
outl(1 << (offset + 16), chip->base + reg);
else
/* high bank register */
errata_outl(chip, 1 << offset, reg);
}
void cs5535_gpio_clear(unsigned offset, unsigned int reg)
{
struct cs5535_gpio_chip *chip = &cs5535_gpio_chip;
unsigned long flags;
spin_lock_irqsave(&chip->lock, flags);
__cs5535_gpio_clear(chip, offset, reg);
spin_unlock_irqrestore(&chip->lock, flags);
}
EXPORT_SYMBOL_GPL(cs5535_gpio_clear);
int cs5535_gpio_isset(unsigned offset, unsigned int reg)
{
struct cs5535_gpio_chip *chip = &cs5535_gpio_chip;
unsigned long flags;
long val;
spin_lock_irqsave(&chip->lock, flags);
if (offset < 16)
/* low bank register */
val = inl(chip->base + reg);
else {
/* high bank register */
val = inl(chip->base + 0x80 + reg);
offset -= 16;
}
spin_unlock_irqrestore(&chip->lock, flags);
return (val & (1 << offset)) ? 1 : 0;
}
EXPORT_SYMBOL_GPL(cs5535_gpio_isset);
/*
* Generic gpio_chip API support.
*/
static int chip_gpio_request(struct gpio_chip *c, unsigned offset)
{
struct cs5535_gpio_chip *chip = (struct cs5535_gpio_chip *) c;
unsigned long flags;
spin_lock_irqsave(&chip->lock, flags);
/* check if this pin is available */
if ((mask & (1 << offset)) == 0) {
dev_info(&chip->pdev->dev,
"pin %u is not available (check mask)\n", offset);
spin_unlock_irqrestore(&chip->lock, flags);
return -EINVAL;
}
/* disable output aux 1 & 2 on this pin */
__cs5535_gpio_clear(chip, offset, GPIO_OUTPUT_AUX1);
__cs5535_gpio_clear(chip, offset, GPIO_OUTPUT_AUX2);
/* disable input aux 1 on this pin */
__cs5535_gpio_clear(chip, offset, GPIO_INPUT_AUX1);
spin_unlock_irqrestore(&chip->lock, flags);
return 0;
}
static int chip_gpio_get(struct gpio_chip *chip, unsigned offset)
{
return cs5535_gpio_isset(offset, GPIO_READ_BACK);
}
static void chip_gpio_set(struct gpio_chip *chip, unsigned offset, int val)
{
if (val)
cs5535_gpio_set(offset, GPIO_OUTPUT_VAL);
else
cs5535_gpio_clear(offset, GPIO_OUTPUT_VAL);
}
static int chip_direction_input(struct gpio_chip *c, unsigned offset)
{
struct cs5535_gpio_chip *chip = (struct cs5535_gpio_chip *) c;
unsigned long flags;
spin_lock_irqsave(&chip->lock, flags);
__cs5535_gpio_set(chip, offset, GPIO_INPUT_ENABLE);
__cs5535_gpio_clear(chip, offset, GPIO_OUTPUT_ENABLE);
spin_unlock_irqrestore(&chip->lock, flags);
return 0;
}
static int chip_direction_output(struct gpio_chip *c, unsigned offset, int val)
{
struct cs5535_gpio_chip *chip = (struct cs5535_gpio_chip *) c;
unsigned long flags;
spin_lock_irqsave(&chip->lock, flags);
__cs5535_gpio_set(chip, offset, GPIO_INPUT_ENABLE);
__cs5535_gpio_set(chip, offset, GPIO_OUTPUT_ENABLE);
if (val)
__cs5535_gpio_set(chip, offset, GPIO_OUTPUT_VAL);
else
__cs5535_gpio_clear(chip, offset, GPIO_OUTPUT_VAL);
spin_unlock_irqrestore(&chip->lock, flags);
return 0;
}
static const char * const cs5535_gpio_names[] = {
"GPIO0", "GPIO1", "GPIO2", "GPIO3",
"GPIO4", "GPIO5", "GPIO6", "GPIO7",
"GPIO8", "GPIO9", "GPIO10", "GPIO11",
"GPIO12", "GPIO13", "GPIO14", "GPIO15",
"GPIO16", "GPIO17", "GPIO18", "GPIO19",
"GPIO20", "GPIO21", "GPIO22", NULL,
"GPIO24", "GPIO25", "GPIO26", "GPIO27",
"GPIO28", NULL, NULL, NULL,
};
static struct cs5535_gpio_chip cs5535_gpio_chip = {
.chip = {
.owner = THIS_MODULE,
.label = DRV_NAME,
.base = 0,
.ngpio = 32,
.names = cs5535_gpio_names,
.request = chip_gpio_request,
.get = chip_gpio_get,
.set = chip_gpio_set,
.direction_input = chip_direction_input,
.direction_output = chip_direction_output,
},
};
static int __init cs5535_gpio_probe(struct pci_dev *pdev,
const struct pci_device_id *pci_id)
{
int err;
ulong mask_orig = mask;
/* There are two ways to get the GPIO base address; one is by
* fetching it from MSR_LBAR_GPIO, the other is by reading the
* PCI BAR info. The latter method is easier (especially across
* different architectures), so we'll stick with that for now. If
* it turns out to be unreliable in the face of crappy BIOSes, we
* can always go back to using MSRs.. */
err = pci_enable_device_io(pdev);
if (err) {
dev_err(&pdev->dev, "can't enable device IO\n");
goto done;
}
err = pci_request_region(pdev, GPIO_BAR, DRV_NAME);
if (err) {
dev_err(&pdev->dev, "can't alloc PCI BAR #%d\n", GPIO_BAR);
goto done;
}
/* set up the driver-specific struct */
cs5535_gpio_chip.base = pci_resource_start(pdev, GPIO_BAR);
cs5535_gpio_chip.pdev = pdev;
spin_lock_init(&cs5535_gpio_chip.lock);
dev_info(&pdev->dev, "allocated PCI BAR #%d: base 0x%llx\n", GPIO_BAR,
(unsigned long long) cs5535_gpio_chip.base);
/* mask out reserved pins */
mask &= 0x1F7FFFFF;
/* do not allow pin 28, Power Button, as there's special handling
* in the PMC needed. (note 12, p. 48) */
mask &= ~(1 << 28);
if (mask_orig != mask)
dev_info(&pdev->dev, "mask changed from 0x%08lX to 0x%08lX\n",
mask_orig, mask);
/* finally, register with the generic GPIO API */
err = gpiochip_add(&cs5535_gpio_chip.chip);
if (err)
goto release_region;
dev_info(&pdev->dev, DRV_NAME ": GPIO support successfully loaded.\n");
return 0;
release_region:
pci_release_region(pdev, GPIO_BAR);
done:
return err;
}
static void __exit cs5535_gpio_remove(struct pci_dev *pdev)
{
int err;
err = gpiochip_remove(&cs5535_gpio_chip.chip);
if (err) {
/* uhh? */
dev_err(&pdev->dev, "unable to remove gpio_chip?\n");
}
pci_release_region(pdev, GPIO_BAR);
}
static struct pci_device_id cs5535_gpio_pci_tbl[] = {
{ PCI_DEVICE(PCI_VENDOR_ID_NS, PCI_DEVICE_ID_NS_CS5535_ISA) },
{ PCI_DEVICE(PCI_VENDOR_ID_AMD, PCI_DEVICE_ID_AMD_CS5536_ISA) },
{ 0, },
};
MODULE_DEVICE_TABLE(pci, cs5535_gpio_pci_tbl);
/*
* We can't use the standard PCI driver registration stuff here, since
* that allows only one driver to bind to each PCI device (and we want
* multiple drivers to be able to bind to the device). Instead, manually
* scan for the PCI device, request a single region, and keep track of the
* devices that we're using.
*/
static int __init cs5535_gpio_scan_pci(void)
{
struct pci_dev *pdev;
int err = -ENODEV;
int i;
for (i = 0; i < ARRAY_SIZE(cs5535_gpio_pci_tbl); i++) {
pdev = pci_get_device(cs5535_gpio_pci_tbl[i].vendor,
cs5535_gpio_pci_tbl[i].device, NULL);
if (pdev) {
err = cs5535_gpio_probe(pdev, &cs5535_gpio_pci_tbl[i]);
if (err)
pci_dev_put(pdev);
/* we only support a single CS5535/6 southbridge */
break;
}
}
return err;
}
static void __exit cs5535_gpio_free_pci(void)
{
cs5535_gpio_remove(cs5535_gpio_chip.pdev);
pci_dev_put(cs5535_gpio_chip.pdev);
}
static int __init cs5535_gpio_init(void)
{
return cs5535_gpio_scan_pci();
}
static void __exit cs5535_gpio_exit(void)
{
cs5535_gpio_free_pci();
}
module_init(cs5535_gpio_init);
module_exit(cs5535_gpio_exit);
MODULE_AUTHOR("Andres Salomon <dilinger@queued.net>");
MODULE_DESCRIPTION("AMD CS5535/CS5536 GPIO driver");
MODULE_LICENSE("GPL");