1
linux/arch/arm/mach-orion5x
Lennert Buytenhek da01bba3cb [ARM] Orion: make PCI handling code deal with Cardbus slots
The Cardbus connector does not have an IDSEL signal, and Cardbus
cards are always the intended target of configuration transactions
on their local PCI bus.  This means that if the Orion's PCI bus
signals are hooked up to a Cardbus slot, the same set of PCI
functions will will appear 31 times, for each of the PCI device
IDs 1-31 (ID 0 is the host bridge).

This patch adds a function to the Orion PCI handling code that board
support code can call to enable Cardbus mode.  When Cardbus mode is
enabled, configuration transactions on the PCI local bus are only
allowed to PCI IDs 0 (host bridge) and 1 (cardbus device).

Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
2008-06-30 16:04:44 -04:00
..
addr-map.c [ARM] Orion: nuke orion5x_{read,write} 2008-06-22 22:44:57 +02:00
common.c
common.h [ARM] Orion: make PCI handling code deal with Cardbus slots 2008-06-30 16:04:44 -04:00
db88f5281-setup.c [ARM] Orion: nuke orion5x_{read,write} 2008-06-22 22:44:57 +02:00
dns323-setup.c [ARM] Orion: nuke orion5x_{read,write} 2008-06-22 22:44:57 +02:00
gpio.c [ARM] Orion: nuke orion5x_{read,write} 2008-06-22 22:44:57 +02:00
irq.c [ARM] Orion: nuke orion5x_{read,write} 2008-06-22 22:44:57 +02:00
Kconfig
kurobox_pro-setup.c [ARM] Orion: initialize UART1 on Kurobox Pro/Linkstation Pro 2008-06-30 14:25:23 -04:00
Makefile
Makefile.boot
mpp.c
mpp.h
mss2-setup.c
mv2120-setup.c [ARM] Orion: correctly load mv2120 RTC driver 2008-06-30 14:25:23 -04:00
pci.c [ARM] Orion: make PCI handling code deal with Cardbus slots 2008-06-30 16:04:44 -04:00
rd88f5182-setup.c
ts78xx-setup.c
ts209-setup.c
ts409-setup.c
tsx09-common.c [ARM] Orion: fix for tsx09-common.c compilation problem 2008-06-30 14:25:23 -04:00
tsx09-common.h
wrt350n-v2-setup.c