fa16a5c13a
Support most of the LDO regulators in the twl4030 family chips. In the case of LDOs supporting MMC/SD, the voltage controls are used; but in most other cases, the regulator framework is only used to enable/disable a supplies, conserving power when a given voltage rail is not needed. The drivers/mfd/twl4030-core.c code already sets up the various regulators according to board-specific configuration, and knows that some chips don't provide the full set of voltage rails. The omitted regulators are intended to be under hardware control, such as during the hardware-mediated system powerup, powerdown, and suspend states. Unless/until software hooks are known to be safe, they won't be exported here. These regulators implement the new get_status() operation, but can't realistically implement get_mode(); the status output is effectively the result of a vote, with the relevant hardware inputs not exposed. Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Acked-by: Mark Brown <broonie@opensource.wolfsonmicro.com> Signed-off-by: Liam Girdwood <lrg@slimlogic.co.uk>
18 lines
530 B
Makefile
18 lines
530 B
Makefile
#
|
|
# Makefile for regulator drivers.
|
|
#
|
|
|
|
|
|
obj-$(CONFIG_REGULATOR) += core.o
|
|
obj-$(CONFIG_REGULATOR_FIXED_VOLTAGE) += fixed.o
|
|
obj-$(CONFIG_REGULATOR_VIRTUAL_CONSUMER) += virtual.o
|
|
|
|
obj-$(CONFIG_REGULATOR_BQ24022) += bq24022.o
|
|
obj-$(CONFIG_REGULATOR_TWL4030) += twl4030-regulator.o
|
|
obj-$(CONFIG_REGULATOR_WM8350) += wm8350-regulator.o
|
|
obj-$(CONFIG_REGULATOR_WM8400) += wm8400-regulator.o
|
|
obj-$(CONFIG_REGULATOR_DA903X) += da903x.o
|
|
obj-$(CONFIG_REGULATOR_PCF50633) += pcf50633-regulator.o
|
|
|
|
ccflags-$(CONFIG_REGULATOR_DEBUG) += -DDEBUG
|