kevin/linux
1
Fork 0
Code
8b8ca9c25f
linux/drivers/gpio/gpio-adp5585.c
Haibo Chen 738bbc660c gpio: adp5585: Add Analog Devices ADP5585 support 
The ADP5585 is a 10/11 input/output port expander with a built in keypad
matrix decoder, programmable logic, reset generator, and PWM generator.
This driver supports the GPIO function using the platform device
registered by the core MFD driver.

The driver is derived from an initial implementation from NXP, available
in commit 451f61b46b76 ("MLK-25917-2 gpio: adp5585-gpio: add
adp5585-gpio support") in their BSP kernel tree. It has been extensively
rewritten.

Signed-off-by: Haibo Chen <haibo.chen@nxp.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Co-developed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Link: https://lore.kernel.org/r/20240722121100.2855-4-laurent.pinchart@ideasonboard.com
Signed-off-by: Lee Jones <lee@kernel.org>
2024-08-01 14:09:28 +01:00

230 lines
6.6 KiB
C
Raw Blame History

// SPDX-License-Identifier: GPL-2.0-only
/*
* Analog Devices ADP5585 GPIO driver
*
* Copyright 2022 NXP
* Copyright 2024 Ideas on Board Oy
*/
#include <linux/device.h>
#include <linux/gpio/driver.h>
#include <linux/mfd/adp5585.h>
#include <linux/module.h>
#include <linux/platform_device.h>
#include <linux/regmap.h>
#include <linux/types.h>
#define ADP5585_GPIO_MAX 11
struct adp5585_gpio_dev {
struct gpio_chip gpio_chip;
struct regmap *regmap;
};
static int adp5585_gpio_get_direction(struct gpio_chip *chip, unsigned int off)
{
struct adp5585_gpio_dev *adp5585_gpio = gpiochip_get_data(chip);
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
unsigned int val;
regmap_read(adp5585_gpio->regmap, ADP5585_GPIO_DIRECTION_A + bank, &val);
return val & bit ? GPIO_LINE_DIRECTION_OUT : GPIO_LINE_DIRECTION_IN;
}
static int adp5585_gpio_direction_input(struct gpio_chip *chip, unsigned int off)
{
struct adp5585_gpio_dev *adp5585_gpio = gpiochip_get_data(chip);
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
return regmap_clear_bits(adp5585_gpio->regmap,
ADP5585_GPIO_DIRECTION_A + bank, bit);
}
static int adp5585_gpio_direction_output(struct gpio_chip *chip, unsigned int off, int val)
{
struct adp5585_gpio_dev *adp5585_gpio = gpiochip_get_data(chip);
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
int ret;
ret = regmap_update_bits(adp5585_gpio->regmap,
ADP5585_GPO_DATA_OUT_A + bank, bit,
val ? bit : 0);
if (ret)
return ret;
return regmap_set_bits(adp5585_gpio->regmap,
ADP5585_GPIO_DIRECTION_A + bank, bit);
}
static int adp5585_gpio_get_value(struct gpio_chip *chip, unsigned int off)
{
struct adp5585_gpio_dev *adp5585_gpio = gpiochip_get_data(chip);
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
unsigned int reg;
unsigned int val;
/*
* The input status register doesn't reflect the pin state when the
* GPIO is configured as an output. Check the direction, and read the
* input status from GPI_STATUS or output value from GPO_DATA_OUT
* accordingly.
*
* We don't need any locking, as concurrent access to the same GPIO
* isn't allowed by the GPIO API, so there's no risk of the
* .direction_input(), .direction_output() or .set() operations racing
* with this.
*/
regmap_read(adp5585_gpio->regmap, ADP5585_GPIO_DIRECTION_A + bank, &val);
reg = val & bit ? ADP5585_GPO_DATA_OUT_A : ADP5585_GPI_STATUS_A;
regmap_read(adp5585_gpio->regmap, reg + bank, &val);
return !!(val & bit);
}
static void adp5585_gpio_set_value(struct gpio_chip *chip, unsigned int off, int val)
{
struct adp5585_gpio_dev *adp5585_gpio = gpiochip_get_data(chip);
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
regmap_update_bits(adp5585_gpio->regmap, ADP5585_GPO_DATA_OUT_A + bank,
bit, val ? bit : 0);
}
static int adp5585_gpio_set_bias(struct adp5585_gpio_dev *adp5585_gpio,
unsigned int off, unsigned int bias)
{
unsigned int bit, reg, mask, val;
/*
* The bias configuration fields are 2 bits wide and laid down in
* consecutive registers ADP5585_RPULL_CONFIG_*, with a hole of 4 bits
* after R5.
*/
bit = off * 2 + (off > 5 ? 4 : 0);
reg = ADP5585_RPULL_CONFIG_A + bit / 8;
mask = ADP5585_Rx_PULL_CFG_MASK << (bit % 8);
val = bias << (bit % 8);
return regmap_update_bits(adp5585_gpio->regmap, reg, mask, val);
}
static int adp5585_gpio_set_drive(struct adp5585_gpio_dev *adp5585_gpio,
unsigned int off, enum pin_config_param drive)
{
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
return regmap_update_bits(adp5585_gpio->regmap,
ADP5585_GPO_OUT_MODE_A + bank, bit,
drive == PIN_CONFIG_DRIVE_OPEN_DRAIN ? bit : 0);
}
static int adp5585_gpio_set_debounce(struct adp5585_gpio_dev *adp5585_gpio,
unsigned int off, unsigned int debounce)
{
unsigned int bank = ADP5585_BANK(off);
unsigned int bit = ADP5585_BIT(off);
return regmap_update_bits(adp5585_gpio->regmap,
ADP5585_DEBOUNCE_DIS_A + bank, bit,
debounce ? 0 : bit);
}
static int adp5585_gpio_set_config(struct gpio_chip *chip, unsigned int off,
unsigned long config)
{
struct adp5585_gpio_dev *adp5585_gpio = gpiochip_get_data(chip);
enum pin_config_param param = pinconf_to_config_param(config);
u32 arg = pinconf_to_config_argument(config);
switch (param) {
case PIN_CONFIG_BIAS_DISABLE:
return adp5585_gpio_set_bias(adp5585_gpio, off,
ADP5585_Rx_PULL_CFG_DISABLE);
case PIN_CONFIG_BIAS_PULL_DOWN:
return adp5585_gpio_set_bias(adp5585_gpio, off, arg ?
ADP5585_Rx_PULL_CFG_PD_300K :
ADP5585_Rx_PULL_CFG_DISABLE);
case PIN_CONFIG_BIAS_PULL_UP:
return adp5585_gpio_set_bias(adp5585_gpio, off, arg ?
ADP5585_Rx_PULL_CFG_PU_300K :
ADP5585_Rx_PULL_CFG_DISABLE);
case PIN_CONFIG_DRIVE_OPEN_DRAIN:
case PIN_CONFIG_DRIVE_PUSH_PULL:
return adp5585_gpio_set_drive(adp5585_gpio, off, param);
case PIN_CONFIG_INPUT_DEBOUNCE:
return adp5585_gpio_set_debounce(adp5585_gpio, off, arg);
default:
return -ENOTSUPP;
};
}
static int adp5585_gpio_probe(struct platform_device *pdev)
{
struct adp5585_dev *adp5585 = dev_get_drvdata(pdev->dev.parent);
struct adp5585_gpio_dev *adp5585_gpio;
struct device *dev = &pdev->dev;
struct gpio_chip *gc;
int ret;
adp5585_gpio = devm_kzalloc(dev, sizeof(*adp5585_gpio), GFP_KERNEL);
if (!adp5585_gpio)
return -ENOMEM;
adp5585_gpio->regmap = adp5585->regmap;
device_set_of_node_from_dev(dev, dev->parent);
gc = &adp5585_gpio->gpio_chip;
gc->parent = dev;
gc->get_direction = adp5585_gpio_get_direction;
gc->direction_input = adp5585_gpio_direction_input;
gc->direction_output = adp5585_gpio_direction_output;
gc->get = adp5585_gpio_get_value;
gc->set = adp5585_gpio_set_value;
gc->set_config = adp5585_gpio_set_config;
gc->can_sleep = true;
gc->base = -1;
gc->ngpio = ADP5585_GPIO_MAX;
gc->label = pdev->name;
gc->owner = THIS_MODULE;
ret = devm_gpiochip_add_data(dev, &adp5585_gpio->gpio_chip,
adp5585_gpio);
if (ret)
return dev_err_probe(dev, ret, "failed to add GPIO chip\n");
return 0;
}
static const struct platform_device_id adp5585_gpio_id_table[] = {
{ "adp5585-gpio" },
{ /* Sentinel */ }
};
MODULE_DEVICE_TABLE(platform, adp5585_gpio_id_table);
static struct platform_driver adp5585_gpio_driver = {
.driver = {
.name = "adp5585-gpio",
},
.probe = adp5585_gpio_probe,
.id_table = adp5585_gpio_id_table,
};
module_platform_driver(adp5585_gpio_driver);
MODULE_AUTHOR("Haibo Chen <haibo.chen@nxp.com>");
MODULE_DESCRIPTION("GPIO ADP5585 Driver");
MODULE_LICENSE("GPL");
View Git Blame Copy Permalink