1da177e4c3
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
30 lines
1.2 KiB
Plaintext
30 lines
1.2 KiB
Plaintext
*** The StrongARM version of the CerfBoard/Cube has been discontinued ***
|
|
|
|
The Intrinsyc CerfBoard is a StrongARM 1110-based computer on a board
|
|
that measures approximately 2" square. It includes an Ethernet
|
|
controller, an RS232-compatible serial port, a USB function port, and
|
|
one CompactFlash+ slot on the back. Pictures can be found at the
|
|
Intrinsyc website, http://www.intrinsyc.com.
|
|
|
|
This document describes the support in the Linux kernel for the
|
|
Intrinsyc CerfBoard.
|
|
|
|
Supported in this version:
|
|
- CompactFlash+ slot (select PCMCIA in General Setup and any options
|
|
that may be required)
|
|
- Onboard Crystal CS8900 Ethernet controller (Cerf CS8900A support in
|
|
Network Devices)
|
|
- Serial ports with a serial console (hardcoded to 38400 8N1)
|
|
|
|
In order to get this kernel onto your Cerf, you need a server that runs
|
|
both BOOTP and TFTP. Detailed instructions should have come with your
|
|
evaluation kit on how to use the bootloader. This series of commands
|
|
will suffice:
|
|
|
|
make ARCH=arm CROSS_COMPILE=arm-linux- cerfcube_defconfig
|
|
make ARCH=arm CROSS_COMPILE=arm-linux- zImage
|
|
make ARCH=arm CROSS_COMPILE=arm-linux- modules
|
|
cp arch/arm/boot/zImage <TFTP directory>
|
|
|
|
support@intrinsyc.com
|