7ebc8d56f4
1. Driver code where pxa_request_dma() is called will most likely reference DMA registers as well, and it is really unnecessary to include pxa-regs.h just for this. Move the definitions into <mach/dma.h> and make relevant drivers include it instead of <mach/pxa-regs.h>. 2. Introduce DMAC_REGS_VIRT as the virtual address base for these DMA registers. This allows later processors to re-use the same IP while registers may start at different I/O address. Signed-off-by: Eric Miao <eric.miao@marvell.com>
103 lines
3.9 KiB
C
103 lines
3.9 KiB
C
/*
|
|
* arch/arm/mach-pxa/include/mach/dma.h
|
|
*
|
|
* Author: Nicolas Pitre
|
|
* Created: Jun 15, 2001
|
|
* Copyright: MontaVista Software, Inc.
|
|
*
|
|
* This program is free software; you can redistribute it and/or modify
|
|
* it under the terms of the GNU General Public License version 2 as
|
|
* published by the Free Software Foundation.
|
|
*/
|
|
#ifndef __ASM_ARCH_DMA_H
|
|
#define __ASM_ARCH_DMA_H
|
|
|
|
#include <mach/hardware.h>
|
|
|
|
/* DMA Controller Registers Definitions */
|
|
#define DMAC_REGS_VIRT io_p2v(0x40000000)
|
|
#define DMAC_REG(x) (*((volatile u32 *)(DMAC_REGS_VIRT + (x))))
|
|
|
|
#define DCSR(n) DMAC_REG((n) << 2)
|
|
#define DALGN DMAC_REG(0x00a0) /* DMA Alignment Register */
|
|
#define DINT DMAC_REG(0x00f0) /* DMA Interrupt Register */
|
|
#define DDADR(n) DMAC_REG(0x0200 + ((n) << 4))
|
|
#define DSADR(n) DMAC_REG(0x0204 + ((n) << 4))
|
|
#define DTADR(n) DMAC_REG(0x0208 + ((n) << 4))
|
|
#define DCMD(n) DMAC_REG(0x020c + ((n) << 4))
|
|
#define DRCMR(n) DMAC_REG((((n) < 64) ? 0x0100 : 0x1100) + \
|
|
(((n) & 0x3f) << 2))
|
|
|
|
#define DCSR_RUN (1 << 31) /* Run Bit (read / write) */
|
|
#define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */
|
|
#define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */
|
|
#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
|
|
#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
|
|
#define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */
|
|
#define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */
|
|
#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */
|
|
|
|
#if defined(CONFIG_PXA27x) || defined(CONFIG_PXA3xx)
|
|
#define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */
|
|
#define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */
|
|
#define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */
|
|
#define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */
|
|
#define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */
|
|
#define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */
|
|
#define DCSR_EORINTR (1 << 9) /* The end of Receive */
|
|
#endif
|
|
|
|
#define DRCMR_MAPVLD (1 << 7) /* Map Valid (read / write) */
|
|
#define DRCMR_CHLNUM 0x1f /* mask for Channel Number (read / write) */
|
|
|
|
#define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor (mask) */
|
|
#define DDADR_STOP (1 << 0) /* Stop (read / write) */
|
|
|
|
#define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */
|
|
#define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */
|
|
#define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */
|
|
#define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */
|
|
#define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */
|
|
#define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */
|
|
#define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */
|
|
#define DCMD_BURST8 (1 << 16) /* 8 byte burst */
|
|
#define DCMD_BURST16 (2 << 16) /* 16 byte burst */
|
|
#define DCMD_BURST32 (3 << 16) /* 32 byte burst */
|
|
#define DCMD_WIDTH1 (1 << 14) /* 1 byte width */
|
|
#define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */
|
|
#define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */
|
|
#define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */
|
|
|
|
/*
|
|
* Descriptor structure for PXA's DMA engine
|
|
* Note: this structure must always be aligned to a 16-byte boundary.
|
|
*/
|
|
|
|
typedef struct pxa_dma_desc {
|
|
volatile u32 ddadr; /* Points to the next descriptor + flags */
|
|
volatile u32 dsadr; /* DSADR value for the current transfer */
|
|
volatile u32 dtadr; /* DTADR value for the current transfer */
|
|
volatile u32 dcmd; /* DCMD value for the current transfer */
|
|
} pxa_dma_desc;
|
|
|
|
typedef enum {
|
|
DMA_PRIO_HIGH = 0,
|
|
DMA_PRIO_MEDIUM = 1,
|
|
DMA_PRIO_LOW = 2
|
|
} pxa_dma_prio;
|
|
|
|
/*
|
|
* DMA registration
|
|
*/
|
|
|
|
int __init pxa_init_dma(int irq, int num_ch);
|
|
|
|
int pxa_request_dma (char *name,
|
|
pxa_dma_prio prio,
|
|
void (*irq_handler)(int, void *),
|
|
void *data);
|
|
|
|
void pxa_free_dma (int dma_ch);
|
|
|
|
#endif /* _ASM_ARCH_DMA_H */
|