622859634a
the MUSB IP is always OTG, so there's no point in adding so many ifdefs on the code. Drop those and always compile the driver for OTG support. This also allows us to drop the useless "driver mode" choice. For doing that, we need to make musb depend on both Host and Peripheral side. Signed-off-by: Felipe Balbi <balbi@ti.com> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
49 lines
1.2 KiB
Makefile
49 lines
1.2 KiB
Makefile
#
|
|
# for USB OTG silicon based on Mentor Graphics INVENTRA designs
|
|
#
|
|
|
|
obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o
|
|
|
|
musb_hdrc-y := musb_core.o
|
|
|
|
musb_hdrc-y += musb_gadget_ep0.o musb_gadget.o
|
|
musb_hdrc-y += musb_virthub.o musb_host.o
|
|
musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o
|
|
|
|
# Hardware Glue Layer
|
|
obj-$(CONFIG_USB_MUSB_OMAP2PLUS) += omap2430.o
|
|
obj-$(CONFIG_USB_MUSB_AM35X) += am35x.o
|
|
obj-$(CONFIG_USB_MUSB_TUSB6010) += tusb6010.o
|
|
obj-$(CONFIG_USB_MUSB_DAVINCI) += davinci.o
|
|
obj-$(CONFIG_USB_MUSB_DA8XX) += da8xx.o
|
|
obj-$(CONFIG_USB_MUSB_BLACKFIN) += blackfin.o
|
|
obj-$(CONFIG_USB_MUSB_UX500) += ux500.o
|
|
|
|
# the kconfig must guarantee that only one of the
|
|
# possible I/O schemes will be enabled at a time ...
|
|
# PIO only, or DMA (several potential schemes).
|
|
# though PIO is always there to back up DMA, and for ep0
|
|
|
|
ifneq ($(CONFIG_MUSB_PIO_ONLY),y)
|
|
|
|
ifeq ($(CONFIG_USB_INVENTRA_DMA),y)
|
|
musb_hdrc-y += musbhsdma.o
|
|
|
|
else
|
|
ifeq ($(CONFIG_USB_TI_CPPI_DMA),y)
|
|
musb_hdrc-y += cppi_dma.o
|
|
|
|
else
|
|
ifeq ($(CONFIG_USB_TUSB_OMAP_DMA),y)
|
|
musb_hdrc-y += tusb6010_omap.o
|
|
|
|
else
|
|
ifeq ($(CONFIG_USB_UX500_DMA),y)
|
|
musb_hdrc-y += ux500_dma.o
|
|
|
|
endif
|
|
endif
|
|
endif
|
|
endif
|
|
endif
|