5cff20e6c5
When we aren't doing anything in mac80211, we can turn off much of the hardware, depending on the driver/hw. Not doing anything, aka being idle, means: * no monitor interfaces * no AP/mesh/wds interfaces * any station interfaces are in DISABLED state * any IBSS interfaces aren't trying to be in a network * we aren't trying to scan By creating a new function that verifies these conditions and calling it at strategic points where the states of those conditions change, we can easily make mac80211 tell the driver when we are idle to save power. Additionally, this fixes a small quirk where a recalculated powersave state is passed to the driver even if the hardware is about to stopped completely. This patch intentionally doesn't touch radio_enabled because that is currently implemented to be a soft rfkill which is inappropriate here when we need to be able to wake up with low latency. One thing I'm not entirely sure about is this: phy0: device no longer idle - in use wlan0: direct probe to AP 00:11:24:91:07:4d try 1 wlan0 direct probe responded wlan0: authenticate with AP 00:11:24:91:07:4d wlan0: authenticated > phy0: device now idle > phy0: device no longer idle - in use wlan0: associate with AP 00:11:24:91:07:4d wlan0: RX AssocResp from 00:11:24:91:07:4d (capab=0x401 status=0 aid=1) wlan0: associated Is it appropriate to go into idle state for a short time when we have just authenticated, but not associated yet? This happens only with the userspace SME, because we cannot really know how long it will wait before asking us to associate. Would going idle after a short timeout be more appropriate? We may need to revisit this, depending on what happens. Signed-off-by: Johannes Berg <johannes@sipsolutions.net> Signed-off-by: John W. Linville <linville@tuxdriver.com> |
||
---|---|---|
.. | ||
aes_ccm.c | ||
aes_ccm.h | ||
aes_cmac.c | ||
aes_cmac.h | ||
agg-rx.c | ||
agg-tx.c | ||
cfg.c | ||
cfg.h | ||
debugfs_key.c | ||
debugfs_key.h | ||
debugfs_netdev.c | ||
debugfs_netdev.h | ||
debugfs_sta.c | ||
debugfs_sta.h | ||
debugfs.c | ||
debugfs.h | ||
driver-ops.h | ||
event.c | ||
ht.c | ||
ibss.c | ||
ieee80211_i.h | ||
iface.c | ||
Kconfig | ||
key.c | ||
key.h | ||
led.c | ||
led.h | ||
main.c | ||
Makefile | ||
mesh_hwmp.c | ||
mesh_pathtbl.c | ||
mesh_plink.c | ||
mesh.c | ||
mesh.h | ||
michael.c | ||
michael.h | ||
mlme.c | ||
pm.c | ||
rate.c | ||
rate.h | ||
rc80211_minstrel_debugfs.c | ||
rc80211_minstrel.c | ||
rc80211_minstrel.h | ||
rc80211_pid_algo.c | ||
rc80211_pid_debugfs.c | ||
rc80211_pid.h | ||
rx.c | ||
scan.c | ||
spectmgmt.c | ||
sta_info.c | ||
sta_info.h | ||
tkip.c | ||
tkip.h | ||
tx.c | ||
util.c | ||
wep.c | ||
wep.h | ||
wext.c | ||
wme.c | ||
wme.h | ||
wpa.c | ||
wpa.h |