kevin/linux
1
Fork 0
Code
59b559d7a3
linux/arch/arm/mach-omap1/board-voiceblue.c
Janusz Krzysztofik c33da3a800 omap1: Fix redundant UARTs pin muxing that can break other hardware support 
Commit 15ac408ee5 removed enabled_uart
and OMAP_TAG_UART. This works for mach-omap2, but causes issues on
mach-omap1 for some boards as the mach-omap1 serial.c was muxing
pins based on the enabled_uart flag for 15xx.

Fix this by muxing pins in board-*.c files for the 15xx boards for
the uart ports that had enabled_uart flag set before the commit
above.

Tested on Amsdtrad Delta only.

Note that in the future we should add support for powering down
the uarts with a timer like mach-omap2/serial.c does. Otherwise
the enabled uarts will be blocking retention-while-idle.

Signed-off-by: Janusz Krzysztofik <jkrzyszt@tis.icnet.pl>
Signed-off-by: Tony Lindgren <tony@atomide.com>
2009-10-22 14:47:42 -07:00

283 lines
6.6 KiB
C
Raw Blame History

/*
* linux/arch/arm/mach-omap1/board-voiceblue.c
*
* Modified from board-generic.c
*
* Copyright (C) 2004 2N Telekomunikace, Ladislav Michl <michl@2n.cz>
*
* Code for OMAP5910 based VoiceBlue board (VoIP to GSM gateway).
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/delay.h>
#include <linux/platform_device.h>
#include <linux/interrupt.h>
#include <linux/irq.h>
#include <linux/init.h>
#include <linux/kernel.h>
#include <linux/notifier.h>
#include <linux/reboot.h>
#include <linux/serial_8250.h>
#include <linux/serial_reg.h>
#include <mach/hardware.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <asm/mach/flash.h>
#include <asm/mach/map.h>
#include <mach/common.h>
#include <mach/gpio.h>
#include <mach/mux.h>
#include <mach/tc.h>
#include <mach/usb.h>
static struct plat_serial8250_port voiceblue_ports[] = {
{
.mapbase = (unsigned long)(OMAP_CS1_PHYS + 0x40000),
.irq = OMAP_GPIO_IRQ(12),
.flags = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
.iotype = UPIO_MEM,
.regshift = 1,
.uartclk = 3686400,
},
{
.mapbase = (unsigned long)(OMAP_CS1_PHYS + 0x50000),
.irq = OMAP_GPIO_IRQ(13),
.flags = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
.iotype = UPIO_MEM,
.regshift = 1,
.uartclk = 3686400,
},
{
.mapbase = (unsigned long)(OMAP_CS1_PHYS + 0x60000),
.irq = OMAP_GPIO_IRQ(14),
.flags = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
.iotype = UPIO_MEM,
.regshift = 1,
.uartclk = 3686400,
},
{
.mapbase = (unsigned long)(OMAP_CS1_PHYS + 0x70000),
.irq = OMAP_GPIO_IRQ(15),
.flags = UPF_BOOT_AUTOCONF | UPF_IOREMAP,
.iotype = UPIO_MEM,
.regshift = 1,
.uartclk = 3686400,
},
{ },
};
static struct platform_device serial_device = {
.name = "serial8250",
.id = PLAT8250_DEV_PLATFORM1,
.dev = {
.platform_data = voiceblue_ports,
},
};
static int __init ext_uart_init(void)
{
return platform_device_register(&serial_device);
}
arch_initcall(ext_uart_init);
static struct flash_platform_data voiceblue_flash_data = {
.map_name = "cfi_probe",
.width = 2,
};
static struct resource voiceblue_flash_resource = {
.start = OMAP_CS0_PHYS,
.end = OMAP_CS0_PHYS + SZ_32M - 1,
.flags = IORESOURCE_MEM,
};
static struct platform_device voiceblue_flash_device = {
.name = "omapflash",
.id = 0,
.dev = {
.platform_data = &voiceblue_flash_data,
},
.num_resources = 1,
.resource = &voiceblue_flash_resource,
};
static struct resource voiceblue_smc91x_resources[] = {
[0] = {
.start = OMAP_CS2_PHYS + 0x300,
.end = OMAP_CS2_PHYS + 0x300 + 16,
.flags = IORESOURCE_MEM,
},
[1] = {
.start = OMAP_GPIO_IRQ(8),
.end = OMAP_GPIO_IRQ(8),
.flags = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHEDGE,
},
};
static struct platform_device voiceblue_smc91x_device = {
.name = "smc91x",
.id = 0,
.num_resources = ARRAY_SIZE(voiceblue_smc91x_resources),
.resource = voiceblue_smc91x_resources,
};
static struct platform_device *voiceblue_devices[] __initdata = {
&voiceblue_flash_device,
&voiceblue_smc91x_device,
};
static struct omap_usb_config voiceblue_usb_config __initdata = {
.hmc_mode = 3,
.register_host = 1,
.register_dev = 1,
.pins[0] = 2,
.pins[1] = 6,
.pins[2] = 6,
};
static struct omap_board_config_kernel voiceblue_config[] = {
};
static void __init voiceblue_init_irq(void)
{
omap1_init_common_hw();
omap_init_irq();
omap_gpio_init();
}
static void __init voiceblue_init(void)
{
/* mux pins for uarts */
omap_cfg_reg(UART1_TX);
omap_cfg_reg(UART1_RTS);
omap_cfg_reg(UART2_TX);
omap_cfg_reg(UART2_RTS);
omap_cfg_reg(UART3_TX);
omap_cfg_reg(UART3_RX);
/* Watchdog */
gpio_request(0, "Watchdog");
/* smc91x reset */
gpio_request(7, "SMC91x reset");
gpio_direction_output(7, 1);
udelay(2); /* wait at least 100ns */
gpio_set_value(7, 0);
mdelay(50); /* 50ms until PHY ready */
/* smc91x interrupt pin */
gpio_request(8, "SMC91x irq");
/* 16C554 reset*/
gpio_request(6, "16C554 reset");
gpio_direction_output(6, 0);
/* 16C554 interrupt pins */
gpio_request(12, "16C554 irq");
gpio_request(13, "16C554 irq");
gpio_request(14, "16C554 irq");
gpio_request(15, "16C554 irq");
set_irq_type(gpio_to_irq(12), IRQ_TYPE_EDGE_RISING);
set_irq_type(gpio_to_irq(13), IRQ_TYPE_EDGE_RISING);
set_irq_type(gpio_to_irq(14), IRQ_TYPE_EDGE_RISING);
set_irq_type(gpio_to_irq(15), IRQ_TYPE_EDGE_RISING);
platform_add_devices(voiceblue_devices, ARRAY_SIZE(voiceblue_devices));
omap_board_config = voiceblue_config;
omap_board_config_size = ARRAY_SIZE(voiceblue_config);
omap_serial_init();
omap_usb_init(&voiceblue_usb_config);
omap_register_i2c_bus(1, 100, NULL, 0);
/* There is a good chance board is going up, so enable power LED
* (it is connected through invertor) */
omap_writeb(0x00, OMAP_LPG1_LCR);
omap_writeb(0x00, OMAP_LPG1_PMR); /* Disable clock */
}
static void __init voiceblue_map_io(void)
{
omap1_map_common_io();
}
#define MACHINE_PANICED 1
#define MACHINE_REBOOTING 2
#define MACHINE_REBOOT 4
static unsigned long machine_state;
static int panic_event(struct notifier_block *this, unsigned long event,
void *ptr)
{
if (test_and_set_bit(MACHINE_PANICED, &machine_state))
return NOTIFY_DONE;
/* Flash power LED */
omap_writeb(0x78, OMAP_LPG1_LCR);
omap_writeb(0x01, OMAP_LPG1_PMR); /* Enable clock */
return NOTIFY_DONE;
}
static struct notifier_block panic_block = {
.notifier_call = panic_event,
};
static int __init voiceblue_setup(void)
{
/* Setup panic notifier */
atomic_notifier_chain_register(&panic_notifier_list, &panic_block);
return 0;
}
postcore_initcall(voiceblue_setup);
static int wdt_gpio_state;
void voiceblue_wdt_enable(void)
{
gpio_direction_output(0, 0);
gpio_set_value(0, 1);
gpio_set_value(0, 0);
wdt_gpio_state = 0;
}
void voiceblue_wdt_disable(void)
{
gpio_set_value(0, 0);
gpio_set_value(0, 1);
gpio_set_value(0, 0);
gpio_direction_input(0);
}
void voiceblue_wdt_ping(void)
{
if (test_bit(MACHINE_REBOOT, &machine_state))
return;
wdt_gpio_state = !wdt_gpio_state;
gpio_set_value(0, wdt_gpio_state);
}
void voiceblue_reset(void)
{
set_bit(MACHINE_REBOOT, &machine_state);
voiceblue_wdt_enable();
while (1) ;
}
EXPORT_SYMBOL(voiceblue_wdt_enable);
EXPORT_SYMBOL(voiceblue_wdt_disable);
EXPORT_SYMBOL(voiceblue_wdt_ping);
MACHINE_START(VOICEBLUE, "VoiceBlue OMAP5910")
/* Maintainer: Ladislav Michl <michl@2n.cz> */
.phys_io = 0xfff00000,
.io_pg_offst = ((0xfef00000) >> 18) & 0xfffc,
.boot_params = 0x10000100,
.map_io = voiceblue_map_io,
.init_irq = voiceblue_init_irq,
.init_machine = voiceblue_init,
.timer = &omap_timer,
MACHINE_END
View Git Blame Copy Permalink