1
linux/drivers/scsi/sata_sis.c
Jeff Garzik aa8f0dc6c3 libata: Fix use-after-iounmap
Jens Axboe pointed out that the iounmap() call in libata was occurring
too early, and some drivers (ahci, probably others) were using ioremap'd
memory after it had been unmapped.

The patch should address that problem by way of improving the libata
driver API:

* move ->host_stop() call after all ->port_stop() calls have occurred.

* create default helper function ata_host_stop(), and move iounmap()
call there.

* add ->host_stop_prewalk() hook, use it in sata_qstor.c (hi Mark).
sata_qstor appears to require the host-stop-before-port-stop ordering
that existed prior to applying the attached patch.
2005-05-26 21:54:27 -04:00

288 lines
7.7 KiB
C

/*
* sata_sis.c - Silicon Integrated Systems SATA
*
* Maintained by: Uwe Koziolek
* Please ALWAYS copy linux-ide@vger.kernel.org
* on emails.
*
* Copyright 2004 Uwe Koziolek
*
* The contents of this file are subject to the Open
* Software License version 1.1 that can be found at
* http://www.opensource.org/licenses/osl-1.1.txt and is included herein
* by reference.
*
* Alternatively, the contents of this file may be used under the terms
* of the GNU General Public License version 2 (the "GPL") as distributed
* in the kernel source COPYING file, in which case the provisions of
* the GPL are applicable instead of the above. If you wish to allow
* the use of your version of this file only under the terms of the
* GPL and not to allow others to use your version of this file under
* the OSL, indicate your decision by deleting the provisions above and
* replace them with the notice and other provisions required by the GPL.
* If you do not delete the provisions above, a recipient may use your
* version of this file under either the OSL or the GPL.
*
*/
#include <linux/config.h>
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/init.h>
#include <linux/blkdev.h>
#include <linux/delay.h>
#include <linux/interrupt.h>
#include "scsi.h"
#include <scsi/scsi_host.h>
#include <linux/libata.h>
#define DRV_NAME "sata_sis"
#define DRV_VERSION "0.5"
enum {
sis_180 = 0,
SIS_SCR_PCI_BAR = 5,
/* PCI configuration registers */
SIS_GENCTL = 0x54, /* IDE General Control register */
SIS_SCR_BASE = 0xc0, /* sata0 phy SCR registers */
SIS_SATA1_OFS = 0x10, /* offset from sata0->sata1 phy regs */
/* random bits */
SIS_FLAG_CFGSCR = (1 << 30), /* host flag: SCRs via PCI cfg */
GENCTL_IOMAPPED_SCR = (1 << 26), /* if set, SCRs are in IO space */
};
static int sis_init_one (struct pci_dev *pdev, const struct pci_device_id *ent);
static u32 sis_scr_read (struct ata_port *ap, unsigned int sc_reg);
static void sis_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
static struct pci_device_id sis_pci_tbl[] = {
{ PCI_VENDOR_ID_SI, 0x180, PCI_ANY_ID, PCI_ANY_ID, 0, 0, sis_180 },
{ PCI_VENDOR_ID_SI, 0x181, PCI_ANY_ID, PCI_ANY_ID, 0, 0, sis_180 },
{ } /* terminate list */
};
static struct pci_driver sis_pci_driver = {
.name = DRV_NAME,
.id_table = sis_pci_tbl,
.probe = sis_init_one,
.remove = ata_pci_remove_one,
};
static Scsi_Host_Template sis_sht = {
.module = THIS_MODULE,
.name = DRV_NAME,
.ioctl = ata_scsi_ioctl,
.queuecommand = ata_scsi_queuecmd,
.eh_strategy_handler = ata_scsi_error,
.can_queue = ATA_DEF_QUEUE,
.this_id = ATA_SHT_THIS_ID,
.sg_tablesize = ATA_MAX_PRD,
.max_sectors = ATA_MAX_SECTORS,
.cmd_per_lun = ATA_SHT_CMD_PER_LUN,
.emulated = ATA_SHT_EMULATED,
.use_clustering = ATA_SHT_USE_CLUSTERING,
.proc_name = DRV_NAME,
.dma_boundary = ATA_DMA_BOUNDARY,
.slave_configure = ata_scsi_slave_config,
.bios_param = ata_std_bios_param,
.ordered_flush = 1,
};
static struct ata_port_operations sis_ops = {
.port_disable = ata_port_disable,
.tf_load = ata_tf_load,
.tf_read = ata_tf_read,
.check_status = ata_check_status,
.exec_command = ata_exec_command,
.dev_select = ata_std_dev_select,
.phy_reset = sata_phy_reset,
.bmdma_setup = ata_bmdma_setup,
.bmdma_start = ata_bmdma_start,
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
.eng_timeout = ata_eng_timeout,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
.scr_read = sis_scr_read,
.scr_write = sis_scr_write,
.port_start = ata_port_start,
.port_stop = ata_port_stop,
.host_stop = ata_host_stop,
};
static struct ata_port_info sis_port_info = {
.sht = &sis_sht,
.host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET |
ATA_FLAG_NO_LEGACY,
.pio_mask = 0x1f,
.mwdma_mask = 0x7,
.udma_mask = 0x7f,
.port_ops = &sis_ops,
};
MODULE_AUTHOR("Uwe Koziolek");
MODULE_DESCRIPTION("low-level driver for Silicon Integratad Systems SATA controller");
MODULE_LICENSE("GPL");
MODULE_DEVICE_TABLE(pci, sis_pci_tbl);
MODULE_VERSION(DRV_VERSION);
static unsigned int get_scr_cfg_addr(unsigned int port_no, unsigned int sc_reg)
{
unsigned int addr = SIS_SCR_BASE + (4 * sc_reg);
if (port_no)
addr += SIS_SATA1_OFS;
return addr;
}
static u32 sis_scr_cfg_read (struct ata_port *ap, unsigned int sc_reg)
{
struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
unsigned int cfg_addr = get_scr_cfg_addr(ap->port_no, sc_reg);
u32 val;
if (sc_reg == SCR_ERROR) /* doesn't exist in PCI cfg space */
return 0xffffffff;
pci_read_config_dword(pdev, cfg_addr, &val);
return val;
}
static void sis_scr_cfg_write (struct ata_port *ap, unsigned int scr, u32 val)
{
struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
unsigned int cfg_addr = get_scr_cfg_addr(ap->port_no, scr);
if (scr == SCR_ERROR) /* doesn't exist in PCI cfg space */
return;
pci_write_config_dword(pdev, cfg_addr, val);
}
static u32 sis_scr_read (struct ata_port *ap, unsigned int sc_reg)
{
if (sc_reg > SCR_CONTROL)
return 0xffffffffU;
if (ap->flags & SIS_FLAG_CFGSCR)
return sis_scr_cfg_read(ap, sc_reg);
return inl(ap->ioaddr.scr_addr + (sc_reg * 4));
}
static void sis_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val)
{
if (sc_reg > SCR_CONTROL)
return;
if (ap->flags & SIS_FLAG_CFGSCR)
sis_scr_cfg_write(ap, sc_reg, val);
else
outl(val, ap->ioaddr.scr_addr + (sc_reg * 4));
}
/* move to PCI layer, integrate w/ MSI stuff */
static void pci_enable_intx(struct pci_dev *pdev)
{
u16 pci_command;
pci_read_config_word(pdev, PCI_COMMAND, &pci_command);
if (pci_command & PCI_COMMAND_INTX_DISABLE) {
pci_command &= ~PCI_COMMAND_INTX_DISABLE;
pci_write_config_word(pdev, PCI_COMMAND, pci_command);
}
}
static int sis_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
{
struct ata_probe_ent *probe_ent = NULL;
int rc;
u32 genctl;
struct ata_port_info *ppi;
int pci_dev_busy = 0;
rc = pci_enable_device(pdev);
if (rc)
return rc;
rc = pci_request_regions(pdev, DRV_NAME);
if (rc) {
pci_dev_busy = 1;
goto err_out;
}
rc = pci_set_dma_mask(pdev, ATA_DMA_MASK);
if (rc)
goto err_out_regions;
rc = pci_set_consistent_dma_mask(pdev, ATA_DMA_MASK);
if (rc)
goto err_out_regions;
ppi = &sis_port_info;
probe_ent = ata_pci_init_native_mode(pdev, &ppi);
if (!probe_ent) {
rc = -ENOMEM;
goto err_out_regions;
}
/* check and see if the SCRs are in IO space or PCI cfg space */
pci_read_config_dword(pdev, SIS_GENCTL, &genctl);
if ((genctl & GENCTL_IOMAPPED_SCR) == 0)
probe_ent->host_flags |= SIS_FLAG_CFGSCR;
/* if hardware thinks SCRs are in IO space, but there are
* no IO resources assigned, change to PCI cfg space.
*/
if ((!(probe_ent->host_flags & SIS_FLAG_CFGSCR)) &&
((pci_resource_start(pdev, SIS_SCR_PCI_BAR) == 0) ||
(pci_resource_len(pdev, SIS_SCR_PCI_BAR) < 128))) {
genctl &= ~GENCTL_IOMAPPED_SCR;
pci_write_config_dword(pdev, SIS_GENCTL, genctl);
probe_ent->host_flags |= SIS_FLAG_CFGSCR;
}
if (!(probe_ent->host_flags & SIS_FLAG_CFGSCR)) {
probe_ent->port[0].scr_addr =
pci_resource_start(pdev, SIS_SCR_PCI_BAR);
probe_ent->port[1].scr_addr =
pci_resource_start(pdev, SIS_SCR_PCI_BAR) + 64;
}
pci_set_master(pdev);
pci_enable_intx(pdev);
/* FIXME: check ata_device_add return value */
ata_device_add(probe_ent);
kfree(probe_ent);
return 0;
err_out_regions:
pci_release_regions(pdev);
err_out:
if (!pci_dev_busy)
pci_disable_device(pdev);
return rc;
}
static int __init sis_init(void)
{
return pci_module_init(&sis_pci_driver);
}
static void __exit sis_exit(void)
{
pci_unregister_driver(&sis_pci_driver);
}
module_init(sis_init);
module_exit(sis_exit);