aa58bec064
Implement register write operation according to the control communication specified in the OPEN Alliance 10BASE-T1x MACPHY Serial Interface document. Control write commands are used by the SPI host to write registers within the MAC-PHY. Each control write commands are composed of a 32 bits control command header followed by register write data. The MAC-PHY ignores the final 32 bits of data from the SPI host at the end of the control write command. The write command and data is also echoed from the MAC-PHY back to the SPI host to enable the SPI host to identify which register write failed in the case of any bus errors. Control write commands can write either a single register or multiple consecutive registers. When multiple consecutive registers are written, the address is automatically post-incremented by the MAC-PHY. Writing to any unimplemented or undefined registers shall be ignored and yield no effect. Reviewed-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Parthiban Veerasooran <Parthiban.Veerasooran@microchip.com> Link: https://patch.msgid.link/20240909082514.262942-3-Parthiban.Veerasooran@microchip.com Signed-off-by: Jakub Kicinski <kuba@kernel.org>
206 lines
6.7 KiB
Plaintext
206 lines
6.7 KiB
Plaintext
# SPDX-License-Identifier: GPL-2.0-only
|
|
#
|
|
# Ethernet LAN device configuration
|
|
#
|
|
|
|
menuconfig ETHERNET
|
|
bool "Ethernet driver support"
|
|
depends on NET
|
|
default y
|
|
help
|
|
This section contains all the Ethernet device drivers.
|
|
|
|
if ETHERNET
|
|
|
|
config MDIO
|
|
tristate
|
|
|
|
source "drivers/net/ethernet/3com/Kconfig"
|
|
source "drivers/net/ethernet/actions/Kconfig"
|
|
source "drivers/net/ethernet/adaptec/Kconfig"
|
|
source "drivers/net/ethernet/aeroflex/Kconfig"
|
|
source "drivers/net/ethernet/agere/Kconfig"
|
|
source "drivers/net/ethernet/alacritech/Kconfig"
|
|
source "drivers/net/ethernet/allwinner/Kconfig"
|
|
source "drivers/net/ethernet/alteon/Kconfig"
|
|
source "drivers/net/ethernet/altera/Kconfig"
|
|
source "drivers/net/ethernet/amazon/Kconfig"
|
|
source "drivers/net/ethernet/amd/Kconfig"
|
|
source "drivers/net/ethernet/apm/Kconfig"
|
|
source "drivers/net/ethernet/apple/Kconfig"
|
|
source "drivers/net/ethernet/aquantia/Kconfig"
|
|
source "drivers/net/ethernet/arc/Kconfig"
|
|
source "drivers/net/ethernet/asix/Kconfig"
|
|
source "drivers/net/ethernet/atheros/Kconfig"
|
|
|
|
config CX_ECAT
|
|
tristate "Beckhoff CX5020 EtherCAT master support"
|
|
depends on PCI
|
|
depends on X86 || COMPILE_TEST
|
|
help
|
|
Driver for EtherCAT master module located on CCAT FPGA
|
|
that can be found on Beckhoff CX5020, and possibly other of CX
|
|
Beckhoff CX series industrial PCs.
|
|
|
|
To compile this driver as a module, choose M here. The module
|
|
will be called ec_bhf.
|
|
|
|
source "drivers/net/ethernet/broadcom/Kconfig"
|
|
source "drivers/net/ethernet/cadence/Kconfig"
|
|
source "drivers/net/ethernet/calxeda/Kconfig"
|
|
source "drivers/net/ethernet/cavium/Kconfig"
|
|
source "drivers/net/ethernet/chelsio/Kconfig"
|
|
source "drivers/net/ethernet/cirrus/Kconfig"
|
|
source "drivers/net/ethernet/cisco/Kconfig"
|
|
source "drivers/net/ethernet/cortina/Kconfig"
|
|
source "drivers/net/ethernet/davicom/Kconfig"
|
|
|
|
config DNET
|
|
tristate "Dave ethernet support (DNET)"
|
|
depends on HAS_IOMEM
|
|
select PHYLIB
|
|
help
|
|
The Dave ethernet interface (DNET) is found on Qong Board FPGA.
|
|
Say Y to include support for the DNET chip.
|
|
|
|
To compile this driver as a module, choose M here: the module
|
|
will be called dnet.
|
|
|
|
source "drivers/net/ethernet/dec/Kconfig"
|
|
source "drivers/net/ethernet/dlink/Kconfig"
|
|
source "drivers/net/ethernet/emulex/Kconfig"
|
|
source "drivers/net/ethernet/engleder/Kconfig"
|
|
source "drivers/net/ethernet/ezchip/Kconfig"
|
|
source "drivers/net/ethernet/faraday/Kconfig"
|
|
source "drivers/net/ethernet/freescale/Kconfig"
|
|
source "drivers/net/ethernet/fujitsu/Kconfig"
|
|
source "drivers/net/ethernet/fungible/Kconfig"
|
|
source "drivers/net/ethernet/google/Kconfig"
|
|
source "drivers/net/ethernet/hisilicon/Kconfig"
|
|
source "drivers/net/ethernet/huawei/Kconfig"
|
|
source "drivers/net/ethernet/i825xx/Kconfig"
|
|
source "drivers/net/ethernet/ibm/Kconfig"
|
|
source "drivers/net/ethernet/intel/Kconfig"
|
|
source "drivers/net/ethernet/xscale/Kconfig"
|
|
|
|
config JME
|
|
tristate "JMicron(R) PCI-Express Gigabit Ethernet support"
|
|
depends on PCI
|
|
select CRC32
|
|
select MII
|
|
help
|
|
This driver supports the PCI-Express gigabit ethernet adapters
|
|
based on JMicron JMC250 chipset.
|
|
|
|
To compile this driver as a module, choose M here. The module
|
|
will be called jme.
|
|
|
|
config KORINA
|
|
tristate "Korina (IDT RC32434) Ethernet support"
|
|
depends on MIKROTIK_RB532 || COMPILE_TEST
|
|
select CRC32
|
|
select MII
|
|
help
|
|
If you have a Mikrotik RouterBoard 500 or IDT RC32434
|
|
based system say Y. Otherwise say N.
|
|
|
|
config LANTIQ_ETOP
|
|
tristate "Lantiq SoC ETOP driver"
|
|
depends on SOC_TYPE_XWAY
|
|
help
|
|
Support for the MII0 inside the Lantiq SoC
|
|
|
|
config LANTIQ_XRX200
|
|
tristate "Lantiq / Intel xRX200 PMAC network driver"
|
|
depends on SOC_TYPE_XWAY
|
|
help
|
|
Support for the PMAC of the Gigabit switch (GSWIP) inside the
|
|
Lantiq / Intel VRX200 VDSL SoC
|
|
|
|
source "drivers/net/ethernet/adi/Kconfig"
|
|
source "drivers/net/ethernet/litex/Kconfig"
|
|
source "drivers/net/ethernet/marvell/Kconfig"
|
|
source "drivers/net/ethernet/mediatek/Kconfig"
|
|
source "drivers/net/ethernet/mellanox/Kconfig"
|
|
source "drivers/net/ethernet/meta/Kconfig"
|
|
source "drivers/net/ethernet/micrel/Kconfig"
|
|
source "drivers/net/ethernet/microchip/Kconfig"
|
|
source "drivers/net/ethernet/mscc/Kconfig"
|
|
source "drivers/net/ethernet/microsoft/Kconfig"
|
|
source "drivers/net/ethernet/moxa/Kconfig"
|
|
source "drivers/net/ethernet/myricom/Kconfig"
|
|
|
|
config FEALNX
|
|
tristate "Myson MTD-8xx PCI Ethernet support"
|
|
depends on PCI
|
|
select CRC32
|
|
select MII
|
|
help
|
|
Say Y here to support the Myson MTD-800 family of PCI-based Ethernet
|
|
cards. <http://www.myson.com.tw/>
|
|
|
|
source "drivers/net/ethernet/ni/Kconfig"
|
|
source "drivers/net/ethernet/natsemi/Kconfig"
|
|
source "drivers/net/ethernet/neterion/Kconfig"
|
|
source "drivers/net/ethernet/netronome/Kconfig"
|
|
source "drivers/net/ethernet/8390/Kconfig"
|
|
source "drivers/net/ethernet/nvidia/Kconfig"
|
|
source "drivers/net/ethernet/nxp/Kconfig"
|
|
source "drivers/net/ethernet/oki-semi/Kconfig"
|
|
|
|
config ETHOC
|
|
tristate "OpenCores 10/100 Mbps Ethernet MAC support"
|
|
depends on HAS_IOMEM && HAS_DMA
|
|
select MII
|
|
select PHYLIB
|
|
select CRC32
|
|
select BITREVERSE
|
|
help
|
|
Say Y here if you want to use the OpenCores 10/100 Mbps Ethernet MAC.
|
|
|
|
config OA_TC6
|
|
tristate "OPEN Alliance TC6 10BASE-T1x MAC-PHY support"
|
|
depends on SPI
|
|
select PHYLIB
|
|
help
|
|
This library implements OPEN Alliance TC6 10BASE-T1x MAC-PHY
|
|
Serial Interface protocol for supporting 10BASE-T1x MAC-PHYs.
|
|
|
|
To know the implementation details, refer documentation in
|
|
<file:Documentation/networking/oa-tc6-framework.rst>.
|
|
|
|
source "drivers/net/ethernet/packetengines/Kconfig"
|
|
source "drivers/net/ethernet/pasemi/Kconfig"
|
|
source "drivers/net/ethernet/pensando/Kconfig"
|
|
source "drivers/net/ethernet/qlogic/Kconfig"
|
|
source "drivers/net/ethernet/brocade/Kconfig"
|
|
source "drivers/net/ethernet/qualcomm/Kconfig"
|
|
source "drivers/net/ethernet/rdc/Kconfig"
|
|
source "drivers/net/ethernet/realtek/Kconfig"
|
|
source "drivers/net/ethernet/renesas/Kconfig"
|
|
source "drivers/net/ethernet/rocker/Kconfig"
|
|
source "drivers/net/ethernet/samsung/Kconfig"
|
|
source "drivers/net/ethernet/seeq/Kconfig"
|
|
source "drivers/net/ethernet/sgi/Kconfig"
|
|
source "drivers/net/ethernet/silan/Kconfig"
|
|
source "drivers/net/ethernet/sis/Kconfig"
|
|
source "drivers/net/ethernet/sfc/Kconfig"
|
|
source "drivers/net/ethernet/smsc/Kconfig"
|
|
source "drivers/net/ethernet/socionext/Kconfig"
|
|
source "drivers/net/ethernet/stmicro/Kconfig"
|
|
source "drivers/net/ethernet/sun/Kconfig"
|
|
source "drivers/net/ethernet/sunplus/Kconfig"
|
|
source "drivers/net/ethernet/synopsys/Kconfig"
|
|
source "drivers/net/ethernet/tehuti/Kconfig"
|
|
source "drivers/net/ethernet/ti/Kconfig"
|
|
source "drivers/net/ethernet/toshiba/Kconfig"
|
|
source "drivers/net/ethernet/tundra/Kconfig"
|
|
source "drivers/net/ethernet/vertexcom/Kconfig"
|
|
source "drivers/net/ethernet/via/Kconfig"
|
|
source "drivers/net/ethernet/wangxun/Kconfig"
|
|
source "drivers/net/ethernet/wiznet/Kconfig"
|
|
source "drivers/net/ethernet/xilinx/Kconfig"
|
|
source "drivers/net/ethernet/xircom/Kconfig"
|
|
|
|
endif # ETHERNET
|