Whenever a transfer is application limited, we are allowed at least
initial window worth of data per window unless cwnd is previously
less than that.
Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@helsinki.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
Overflow can occur very easily with 32 bits, e.g., with 1 second
us_idle is approx. 2^20, which leaves only 11-Wlog bits for queue
length. Since the EWMA exponent is typically around 9, queue
lengths larger than 2^2 cause overflow. Whether the affected
branch is taken when us_idle is as high as 1 second, depends on
Scell_log, but with rather reasonable configuration Scell_log is
large enough to cause p->Stab to have zero index, which always
results zero shift (typically also few other small indices result
in zero shift).
Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@helsinki.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
The datagram interface of LLC is broken in a couple of ways.
These were discovered when trying to use it to build an out-of-kernel
version of STP.
First it didn't pass the source address of the received packet
in recvfrom(). It needs to copy the source address of received LLC packets
into the socket control block. At the same time fix a security issue
because there was uninitialized data leakage. Every recvfrom call
was just copying out old data.
Second, LLC should not merge multiple packets in one receive call
on datagram sockets. LLC should preserve packet boundaries on
SOCK_DGRAM.
This fix goes against the old historical comments about UNIX98 semantics
but without this fix SOCK_DGRAM is broken and useless. So either ANK's
interpretation was incorect or UNIX98 standard was wrong.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Acked-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Fix code that passes back netlink status messages about
bridge changes. Submitted by Aji_Srinivas@emc.com
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
By using milliseconds instead of jiffies to calculate acceleration
factor we make the code immune to changes in HZ.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
When emulating button toggle drivers need to send input_sync()
between 'down' and 'up' events, otherwise some users might miss
keypress because device's state is only considered finalized
after EV_SYN/SYN_REPORT is received.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Trackpoint driver was not sending the magic knock sequence upon resume
causing incorrect device behavior after resuming from disk.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
MX300 does not have an EXTRA_BTN - it is a simple wheel mouse with
an additional task-switcher button, which is reported as side button
(and not task button).
Signed-off-by: Daniel Drake <dsd@gentoo.org>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
In the error path, ata_device_add()
* dereferences null host_set->ports[] element.
* calls scsi_remove_host() on not-yet-added shost.
This patch fixes both bugs. The first problem was spotted and initial
patch submitted by Dave Jones <davej@redhat.com>. The second problem
was mentioned and fixed by Jeff Garzik <jgarzik@pobox.com> in a larger
cleanup patch.
Cc: Dave Jones <davej@redhat.com>
Cc: Jeff Garzik <jgarzik@pobox.com>
Signed-off-by: Tejun Heo <htejun@gmail.com>
sata_sil24 doesn't make use of probe_ent->mmio_base and setting this
field causes the area to be released twice on detach. Don't set
probe_ent->mmio_base.
Signed-off-by: Tejun Heo <htejun@gmail.com>
To get host_set->private_data initialized reliably, all pinfos need to
point to the same hpriv. Restore pinfo->private_data after pata pinfo
assignment.
Signed-off-by: Tejun Heo <htejun@gmail.com>
ata_prot_detach() did nothing for old EH ports and thus SCSI hosts
associated with those ports are left dangling after they are detached
leaving stale devices and causing oops eventually. Make
ata_port_detach() remove SCSI hosts for old EH ports.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Drivers expect to be able to call wireless_send_event in arbitrary
contexts. On the other hand, netlink really doesn't like being
invoked in an IRQ context. So we need to postpone the sending of
netlink skb's to a tasklet.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
The uncached allocator has a function, uncached_get_new_chunk(), that needs
to be serialized on a per node basis. It also has a global variable,
allocated_granules, which should be defined on a per node basis and protected
by that serialization. Additionally, all error returns from functions called
(like ia64_pal_mc_drain()) should be handled appropriately.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Acked-by: Jes Sorenson <jes@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
* 'fixes' of git://git.linux-nfs.org/pub/linux/nfs-2.6:
SUNRPC: Fix obvious refcounting bugs in rpc_pipefs.
RPC: Ensure that we disconnect TCP socket when client requests error out
NLM/lockd: remove b_done
NFS: make 2 functions static
NFS: Release dcache_lock in an error path of nfs_path
* master.kernel.org:/pub/scm/linux/kernel/git/davej/cpufreq:
[CPUFREQ] Propagate acpi_processor_preregister_performance return value.
[CPUFREQ] [2/2] demand load governor modules.
[CPUFREQ] [1/2] add __find_governor helper and clean up some error handling.
[CPUFREQ] Longhaul - Rename & fix multipliers table
[CPUFREQ] Longhaul - Fix power state test to do something more useful
[CPUFREQ] Longhaul - Readd accidentally dropped line
[CPUFREQ] Make longhaul_walk_callback() static
[CPUFREQ] X86_GX_SUSPMOD must depend on PCI
[CPUFREQ] Longhaul - Initialise later.
[CPUFREQ] Longhaul - Workaround issues with APIC.
[CPUFREQ] Longhaul - Hook into ACPI C states.
[CPUFREQ] return error when failing to set minfreq
* 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/libata-dev:
[PATCH] ahci: skip protocol test altogether in spurious interrupt code
* git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/pci-2.6:
PNP: Add missing casts in printk() arguments
PCI: docking station: remove dock uevents
PCI: Unhide the SMBus on Asus PU-DLS
PCI Hotplug: add acpiphp to MAINTAINERS
PCI: pci/search: EXPORTs cannot be __devinit
PCIE: cleanup on probe error
pcie: fix warnings when CONFIG_PM=n
Skip protocol test altogether in spurious interrupt code. If PIOS is received
when it shouldn't, ahci will raise protocol violation.
Signed-off-by: Unicorn Chang <uchang@tw.ibm.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
When writing the firmware to the NIC, the FIFO is 256-bytes long,
so we use 256-bytes chunks and a read to wait until the previous
write is done.
Signed-off-by: Brice Goglin <brice@myri.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
Prevent phylib from freeing PHY IRQ twice on closing an eth device:
phy_disconnect() first calls phy_stop_interrupts(), then it calls
phy_stop_machine() which in turn calls phy_stop_interrupts() making the
kernel complain on each bootup...
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
This patch contains some of the bug fixes and enhancements done to
s2io driver. Following are the brief description of changes
1. code cleanup to handle gso modification better
2. Move repeated code in rx path, to a common function
s2io_chk_rx_buffers()
3. Bug fix in MSI interrupt
4. clear statistics when card is down
5. Avoid linked list traversing in lro aggregation.
6. Use pci_dma_sync_single_for_cpu for buffer0 in case of 2/3
buffer mode.
7. ethtool tso get/set functions to set clear NETIF_F_TSO6
8. Stop LRO aggregation when we receive ECN notification
Signed-off-by: Ananda Raju <ananda.raju@neterion.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
This patch contains some of the bug fixes and enhancements done to
s2io driver. Following are the brief description of changes
1. Introduced macro "S2IO_PARM_INT" for declaring integer load parameter
2. UDP_RR test failure, memset txdl after Tx completion
3. PXE boot may leave adapter in unknown state so do reset in probe.
4. Add Tx completion code in netpoll
5. In s2io_vpd_read() move array vpd_data[] to pointer, saves stack memory
6. Fix bug in ethtool online test
Signed-off-by: Ananda Raju <ananda.raju@neterion.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
If we're part way through transmitting a TCP request, and the client
errors, then we need to disconnect and reconnect the TCP socket in order to
avoid confusing the server.
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
(cherry picked from 031a50c8b9ea82616abd4a4e18021a25848941ce commit)
We never actually set the b_done field any more; it's always zero.
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
(cherry picked from af8412d4283ef91356e65e0ed9b025b376aebded commit)
nfs_writedata_free() and nfs_readdata_free() can now become static.
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Cc: Trond Myklebust <trond.myklebust@fys.uio.no>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
(cherry picked from 5e1ce40f0c3c8f67591aff17756930d7a18ceb1a commit)
In one of the error paths of nfs_path, it may return with dcache_lock still
held; fix this by adding and using a new error path Elong_unlock which unlocks
dcache_lock.
Signed-off-by: Josh Triplett <josh@freedesktop.org>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>
(cherry picked from f4b90b43677fb23297c56802c3056fc304f988d9 commit)
Some resource_size_t values are fed to printk() without handling the fact
that they can have different size depending on your .config.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Remove uevent dock notifications. There are no consumers
of these events at present, and uevents are likely not the
correct way to send this type of event anyway.
Until I get some kind of idea if anyone in userspace cares
about dock events, I will just not send any.
Signed-off-by: Kristen Carlson Accardi <kristen.c.accardi@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Unhide the SMBus controller on the Asus PU-DLS board.
This fixes bug #6763.
Signed-off-by: Jean Delvare <khali@linux-fr.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Add acpiphp to the MAINTAINERS file.
Signed-off-by: Kristen Carlson Accardi <kristen.c.accardi@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
If pcie_portdrv_probe() fails but it had already called
pci_enable_device(), then call pci_disable_device() when
returning error.
Is there some reason that this isn't being done?
or was it just missed?
Signed-off-by: Randy Dunlap <rdunlap@xenotime.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Wait until all users have closed their device context before allowing
device unregistration to complete. This prevents a crash caused by
referring to stale data structures.
A better solution would be to have a way to revoke contexts rather
than waiting for userspace to close the context, but that's a much
bigger change that will have to wait. For now let's at least avoid
the crash.
Signed-off-by: Jack Morgenstein <jackm@mellanox.co.il>
Signed-off-by: Michael S. Tsirkin <mst@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
