The udbg low level io layer has an issue with udbg_getc() returning a
char (unsigned on ppc) instead of an int, thus the -1 if you had no
available input device could end up turned into 0xff, filling your
display with bogus characters. This fixes it, along with adding a little
blob to xmon to do a delay before exiting when getting an EOF and fixing
the detection of ADB keyboards in udbg_adb.c
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Paul Mackerras <paulus@samba.org>
arch/powerpc/xmon/xmon.c:525: error: syntax error before "xmon_irq"
arch/powerpc/xmon/xmon.c:526: warning: return type defaults to `int'
arch/powerpc/xmon/xmon.c: In function `xmon_irq':
arch/powerpc/xmon/xmon.c:532: error: `IRQ_HANDLED' undeclared (first use in this function)
arch/powerpc/xmon/xmon.c:532: error: (Each undeclared identifier is reported only once
arch/powerpc/xmon/xmon.c:532: error: for each function it appears in.)
Cc: Paul Mackerras <paulus@samba.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
When we created the instructions to read/write SPRs in xmon, we were
setting up a ppc64-style procedure descriptor and calling that, which
doesn't work in 32-bit. For 32-bit a function pointer just points
to the instructions of the function. This fixes it to do the right
thing for both 32-bit and 64-bit.
Signed-off-by: Paul Mackerras <paulus@samba.org>
This makes the memory examine/change command print the address as
8 digits instead of 16, and makes the memory dump command print
4 4-byte values per line instead of 2 8-byte values.
Signed-off-by: Paul Mackerras <paulus@samba.org>
This factors out the common bits of arch/powerpc/xmon/start_*.c into
a new nonstdio.c, and removes some stuff that was supposed to make
xmon's I/O routines somewhat stdio-like but was never used.
It also makes the parsing of the xmon= command line option common,
so that ppc32 can now use xmon={off,on,early} also.
Signed-off-by: Paul Mackerras <paulus@samba.org>
The merged version follows the ppc64 version pretty closely mostly,
and in fact ARCH=ppc64 now uses the arch/powerpc/xmon version.
The main difference for ppc64 is that the 'p' command to call
show_state (which was always pretty dodgy) has been replaced by
the ppc32 'p' command, which calls a given procedure (so in fact
the old 'p' command behaviour can be achieved with 'p $show_state').
Signed-off-by: Paul Mackerras <paulus@samba.org>
