There is no need for irq_desc here. Even for sparse_irq we can
handle this clever in for_each_irq_nr().
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
This code is not ready, but we need to rip it out instead of rebasing
as we would lose the APIC/IO_APIC unification otherwise.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Revert the sparse irq changes in m68k/s390/sparc and just define
nr_irqs as NR_IRQS for those architectures.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Create /sys/firmware/sgi_uv sysfs entries for partition_id and coherence_id.
Signed-off-by: Russ Anderson <rja@sgi.com>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Add a bios call to return partitioning related info.
Signed-off-by: Russ Anderson <rja@sgi.com>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Add the EFI callback function and associated wrapper code.
Initialize SAL system table entry info at boot time.
Signed-off-by: Russ Anderson <rja@sgi.com>
Signed-off-by: Paul Jackson <pj@sgi.com>
Acked-by: Huang Ying <ying.huang@intel.com>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Look for a UV entry in the EFI tables.
Signed-off-by: Russ Anderson <rja@sgi.com>
Signed-off-by: Paul Jackson <pj@sgi.com>
Acked-by: Huang Ying <ying.huang@intel.com>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Provide a means for UV interrupt MMRs to be setup with the message to be sent
when an MSI is raised.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Very early detection of the DMAR tables will setup fixmap mapping. For
parsing these tables later (while enabling dma and/or interrupt remapping),
early fixmap mapping shouldn't be used. Fix it by calling table detection
routines again, which will call generic apci_get_table() for setting up
the correct mapping.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
APIC_ARBPRI is a reserved register for XAPIC and beyond.
APIC_RRR is a reserved register except for 82489DX, APIC for Pentium processors.
APIC_EOI is a write only register.
APIC_DFR is reserved in x2apic mode.
Access to these registers in x2apic will result in #GP fault. Fix these
apic register accesses.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Cc: Maciej W. Rozycki <macro@linux-mips.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
According to entry_64.S we do pass pt_regs pointer
into interrupt handlers but don't use them. So we
safely may merge the declarations.
Signed-off-by: Cyrill Gorcunov <gorcunov@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
for !CONFIG_HAVE_SPARSE_IRQ
fix:
In file included from arch/x86/kernel/early-quirks.c:18:
include/asm/io_apic.h: In function 'probe_nr_irqs':
include/asm/io_apic.h:209: error: 'NR_IRQS' undeclared (first use in this function)
include/asm/io_apic.h:209: error: (Each undeclared identifier is reported only once
include/asm/io_apic.h:209: error: for each function it appears in.)
v2: fix by Ingo
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
we are using 28bit pci (bus/dev/fn + 12 bits) as irq number, so the
cache for irq number should be 32 bit too.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
let user decide the meaning of the bits.
This unifies the 32-bit and 64-bit io-apic code a bit.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
so we can merge io_apic_32.c and io_apic_64.c
v2: Use cpu_online_map as target cpus for bigsmp, just like 64-bit is doing.
Also remove some unused TARGET_CPUS macro.
v3: need to check if desc is null in smp_irq_move_cleanup
also migration needs to reset vector too, so copy __target_IO_APIC_irq
from 64bit.
(the duplication will go away once the two files are unified.)
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
This has been deprecated for years, the user space irqbalanced utility
works better with numa, has configurable policies, etc...
Signed-off-by: Yinghai Lu <yhlu.kernel@gmai.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
also print out irq no in /proc/interrups and /proc/stat in hex, so could
tell bus/dev/func.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
when CONFIG_HAVE_SPARSE_IRQ
preallocate some irq_2_iommu entries, and use get_one_free_irq_2_iomm to
get new one and link to irq_desc if needed.
else will use dyn_array or static array.
v2: <= nr_irqs fix
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
change names:
irq_desc() ==> irq_desc_alloc
__irq_desc() ==> irq_desc
Also split a few of the uses in lowlevel x86 code.
v2: need to check if desc is null in smp_irq_move_cleanup
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
So we could remove some duplicated calling to irq_desc
v2: make sure irq_desc in init/main.c is not used without generic_hardirqs
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Replace another nr_irqs loop to avoid the allocation of all sparse
irq entries - use for_each_irq_desc instead.
v2: make sure arch without GENERIC_HARDIRQS works too
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
There are a handful of loops that go from 0 to nr_irqs and use
get_irq_desc() on them. These would allocate all the irq_desc
entries, regardless of the need for them.
Use the smarter for_each_irq_desc() iterator that will only iterate
over the present ones.
v2: make sure arch without GENERIC_HARDIRQS work too
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
add an irq_desc accessor that will not allocate any sparse entry
but returns failure if there's no entry present.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
based on Eric's patch ...
together mold it with dyn_array for irq_desc, will allcate kstat_irqs for
nr_irq_desc alltogether if needed. -- at that point nr_cpus is known already.
v2: make sure system without generic_hardirqs works they don't have irq_desc
v3: fix merging
v4: [mingo@elte.hu] fix typo
[ mingo@elte.hu ] irq: build fix
fix:
arch/x86/xen/spinlock.c: In function 'xen_spin_lock_slow':
arch/x86/xen/spinlock.c:90: error: 'struct kernel_stat' has no member named 'irqs'
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
irq_timer_state[] is a NR_IRQS sized array that is a side-by array to
the real irq_desc[] array.
Integrate that field into the (now dynamic) irq_desc dynamic array and
save some RAM.
v2: keep the old way to support arch not support irq_desc
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
add CONFIG_HAVE_SPARSE_IRQ to for use condensed array.
Get rid of irq_desc[] array assumptions.
Preallocate 32 irq_desc, and irq_desc() will try to get more.
( No change in functionality is expected anywhere, except the odd build
failure where we missed a code site or where a crossing commit itroduces
new irq_desc[] usage. )
v2: according to Eric, change get_irq_desc() to irq_desc()
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Until now, NR_IRQS was derived from black magic defines that had to
be "large enough" to both accomodate NR_CPUS and MAX_NR_IO_APICs.
This resulted in a way too large irq_desc[] array on most x86 systems.
Especially with larger CPU masks, the size of irq_desc can spiral out
of control quickly.
So be smarter about it and use precise allocation instead: determine the
default maximum possible IRQ number from the ACPI MADT. Use a minimum limit
of at least 32 IRQs for broken BIOSes.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
also add first_free_entry and pin_map_size, which were NR_IRQS derived
constants.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
at this point nr_irqs is equal NR_IRQS
convert a few easy users from NR_IRQS to dynamic nr_irqs.
v2: according to Eric, we need to take care of arch without generic_hardirqs
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
so could spare some memory with small alignment in bootmem
also tighten the alignment checking, and make print out less debug info.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jikos/hid: (55 commits)
HID: build drivers for all quirky devices by default
HID: add missing blacklist entry for Apple ATV ircontrol
HID: add support for Bright ABNT2 brazilian device
HID: Don't let Avermedia Radio FM800 be handled by usb hid drivers
HID: fix numlock led on Dell device 0x413c/0x2105
HID: remove warn() macro from usb hid drivers
HID: remove info() macro from usb HID drivers
HID: add appletv IR receiver quirk
HID: fix a lockup regression when using force feedback on a PID device
HID: hiddev.h: Fix example code.
HID: hiddev.h: Fix mixed space and tabs in example code.
HID: convert to dev_* prints
HID: remove hid-ff
HID: move zeroplus FF processing
HID: move thrustmaster FF processing
HID: move pantherlord FF processing
HID: fix incorrent length condition in hidraw_write()
HID: fix tty<->hid deadlock
HID: ignore iBuddy devices
HID: report descriptor fix for remaining MacBook JIS keyboards
...
