The name argument of request_irq() appears in /proc/interrupts, and
it's quite ugly when the name entry contains a space or special letters.
In general, it's simpler and more readable when the module name appears
there, so let's replace all entries with KBUILD_MODNAME.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The convention for pci_driver.name entry in kernel drivers seem to be
the module name or equivalent ones. But, so far, almost all PCI sound
drivers use more verbose name like "ABC Xyz (12)", and these are fairly
confusing when appearing as a file name.
This patch converts the all pci_driver.name entries in sound/pci/* to
use KBUILD_MODNAME for more unified appearance.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Renamed to Digial SRC Capture Switch for more correct representation.
Also fixed analog volume control on Lola161611 and lola881.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
For assuring the synchronized state with the pause operation,
loop over the all linked streams and waits until all get ready
in a loop.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Added the refcounting for the exclusive SRC control.
Also, fixed the possible stall after PCM pause operations.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Added granularity and sample_rate_min module options.
The former controls the h/w access granularity. As default, it's set
to the max value 32.
The latter controls the minimum sample rate in Hz, as default 16000.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Use a single BDL for both buffers instead of allocating for each.
Also a few tune-up to avoid the stream stalls in the PCM code and
the prelimianry work for SG-buffer support are added, too.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The codec proc file becomes a read only that shows the codec widgets
in a text form. A new proc file, codec_rw, is introduced instead for
accessing the Lola verb directly by reading and writing to it.
Also, regs proc file shows the contents of DSD, too.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Added a new driver for supporting Digigram Lola PCI-e boards.
Lola has a similar h/w design like HD-audio but with extended verbs.
Thus the driver is written similarly like HD-audio driver in the bus
part. The codec part is rather written in a fixed way specific to the
Lola board because of the verb incompatibility.
The driver provides basic PCM, supporting multi-streams and mixing.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
