Add pinctrl and GPIO controller driver support to Arbel BMC NPCM8XX SoC.
Arbel BMC NPCM8XX pinctrl driver based on Poleg NPCM7XX, except the
pin mux mapping difference the NPCM8XX GPIO supports adjust debounce
period time.
Signed-off-by: Tomer Maimon <tmaimon77@gmail.com>
Link: https://lore.kernel.org/r/20230828140849.21724-3-tmaimon77@gmail.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This driver is based on the one for NPCM7xx, because the WPCM450 is a
predecessor of those SoCs. Notable differences:
- On WPCM450, the GPIO registers are not organized in multiple banks,
but rather placed continually into the same register block. This
affects how register offsets are computed.
- Pinmux nodes can explicitly select GPIO mode, whereas in the npcm7xx
driver, this happens automatically when a GPIO is requested.
Some functionality implemented in the hardware was (for now) left unused
in the driver, specifically blinking and pull-up/down.
Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net>
Reported-by: kernel test robot <lkp@intel.com>
Link: https://lore.kernel.org/r/20220129115228.2257310-6-j.neuschaefer@gmx.net
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
