kevin/linux
1
Fork 0
Code
f8beab2bb6
linux/drivers/base/regmap/Makefile

6 lines
262 B
Makefile
Raw Normal View History

regmap: Add the LZO cache support This patch adds support for LZO compression when storing the register cache. For a typical device whose register map would normally occupy 25kB or 50kB by using the LZO compression technique, one can get down to ~5-7kB. There might be a performance penalty associated with each individual read/write due to decompressing/compressing the underlying cache, however that should not be noticeable. These memory benefits depend on whether the target architecture can get rid of the memory occupied by the original register defaults cache which is marked as __devinitconst. Nevertheless there will be some memory gain even if the target architecture can't get rid of the original register map, this should be around ~30-32kB instead of 50kB. Signed-off-by: Dimitris Papastamos <dp@opensource.wolfsonmicro.com> Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-09-19 06:34:03 -07:00
obj-$(CONFIG_REGMAP) += regmap.o regcache.o regcache-indexed.o regcache-rbtree.o regcache-lzo.o
regmap: Provide register map dump via debugfs Copy over the read parts of the ASoC debugfs implementation into regmap, allowing users to see what the register values the device has are at runtime. The implementation, especially the support for seeking, is mostly due to Dimitris Papastamos' work in ASoC. Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-07-20 14:56:53 -07:00
obj-$(CONFIG_DEBUG_FS) += regmap-debugfs.o
regmap: Add I2C bus support Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com> Acked-by: Liam Girdwood <lrg@ti.com> Acked-by: Wolfram Sang <w.sang@pengutronix.de> Acked-by: Grant Likely <grant.likely@secretlab.ca>
2011-06-20 11:02:29 -07:00
obj-$(CONFIG_REGMAP_I2C) += regmap-i2c.o
regmap: Add SPI bus support Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com> Acked-by: Liam Girdwood <lrg@ti.com> Acked-by: Wolfram Sang <w.sang@pengutronix.de> Acked-by: Grant Likely <grant.likely@secretlab.ca>
2011-05-12 02:42:10 -07:00
obj-$(CONFIG_REGMAP_SPI) += regmap-spi.o
regmap: Add a reusable irq_chip for regmap based interrupt controllers There seem to be lots of regmap-using devices with very similar interrupt controllers with a small bank of interrupt registers and mask registers with an interrupt per bit. This won't cover everything but it's a good start. Each chip supplies a base for the status registers, a base for the mask registers, an optional base for writing acknowledgements (which may be the same as the status registers) and an array of bits within each of these register banks which indicate the interrupt. There is an assumption that the bit for each interrupt will be the same in each of the register bank. Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
2011-10-28 14:50:49 -07:00
obj-$(CONFIG_REGMAP_IRQ) += regmap-irq.o
Copy Permalink