kevin/linux
1
Fork 0
Code
71b755b08e
linux/drivers/pci/Kconfig

72 lines
1.9 KiB
Plaintext
Raw Normal View History

Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
2005-04-16 15:20:36 -07:00
#
# PCI configuration
#
msi: introduce ARCH_SUPPORTS_MSI Kconfig option (rev2) Allows architectures to advertise that they support MSI rather than listing each architecture as a PCI_MSI dependency. Signed-off-by: Dan Williams <dan.j.williams@intel.com> Acked-by: "Eric W. Biederman" <ebiederm@xmission.com> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
2007-04-18 01:46:20 -07:00
config ARCH_SUPPORTS_MSI
bool
default n
Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
2005-04-16 15:20:36 -07:00
config PCI_MSI
bool "Message Signaled Interrupts (MSI and MSI-X)"
depends on PCI
msi: introduce ARCH_SUPPORTS_MSI Kconfig option (rev2) Allows architectures to advertise that they support MSI rather than listing each architecture as a PCI_MSI dependency. Signed-off-by: Dan Williams <dan.j.williams@intel.com> Acked-by: "Eric W. Biederman" <ebiederm@xmission.com> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
2007-04-18 01:46:20 -07:00
depends on ARCH_SUPPORTS_MSI
Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
2005-04-16 15:20:36 -07:00
help
This allows device drivers to enable MSI (Message Signaled
Interrupts). Message Signaled Interrupts enable a device to
generate an interrupt using an inbound Memory Write on its
PCI bus instead of asserting a device IRQ pin.
[PATCH] PCI: Provide a boot parameter to disable MSI Several drivers are starting to grow options to disable MSI. However, it's often a host chipset issue, not something which individual drivers should handle. So we add the pci=nomsi kernel parameter to allow the user to disable MSI modes for systems we haven't added to the quirk list yet. Signed-off-by: Matthew Wilcox <matthew@wil.cx> Signed-off-by: Randy Dunlap <rdunlap@xenotime.net> Acked-by: Jeff Garzik <jeff@garzik.org> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
2006-03-05 22:33:34 -07:00
Use of PCI MSI interrupts can be disabled at kernel boot time
by using the 'pci=nomsi' option. This disables MSI for the
entire system.
Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
2005-04-16 15:20:36 -07:00
If you don't know what to do here, say N.
PCI: Add Kconfig option to disable deprecated pci_find_* API Signed-off-by: Jeff Garzik <jgarzik@redhat.com> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
2007-10-29 06:48:09 -07:00
config PCI_LEGACY
bool "Enable deprecated pci_find_* API"
depends on PCI
default y
help
Say Y here if you want to include support for the deprecated
pci_find_slot() and pci_find_device() APIs. Most drivers have
been converted over to using the proper hotplug APIs, so this
option serves to include/exclude only a few drivers that are
still using this API.
Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
2005-04-16 15:20:36 -07:00
config PCI_DEBUG
bool "PCI Debugging"
depends on PCI && DEBUG_KERNEL
help
Say Y here if you want the PCI core to produce a bunch of debug
messages to the system log. Select this if you are having a
problem with PCI support and want to see more of what is going on.
When in doubt, say N.
PCI: pci-stub module to reserve pci device When doing device assignment with KVM there's currently nothing to protect the device from having a driver in the host as well as the guest. This trivial module just binds the pci device on the host to a stub driver so that a real host driver can't bind to the device. It has no pci id table, it supports only dynamic ids. # echo "8086 10f5" > /sys/bus/pci/drivers/pci-stub/new_id # echo -n 0000:00:19.0 > /sys/bus/pci/drivers/e1000e/unbind # echo -n 0000:00:19.0 > /sys/bus/pci/drivers/pci-stub/bind # ls -l /sys/bus/pci/devices/0000:00:19.0/driver lrwxrwxrwx 1 root root 0 2008-11-25 19:10 /sys/bus/pci/devices/0000:00:19.0/driver -> ../../../bus/pci/drivers/pci-stub Cc: "Kay, Allen M" <allen.m.kay@intel.com> Cc: "Nakajima, Jun" <jun.nakajima@intel.com> Signed-off-by: Chris Wright <chrisw@sous-sol.org> Acked-by: Greg Kroah-Hartman <gregkh@suse.de> Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
2008-11-25 22:17:13 -07:00
config PCI_STUB
tristate "PCI Stub driver"
depends on PCI
help
Say Y or M here if you want be able to reserve a PCI device
when it is going to be assigned to a guest operating system.
When in doubt, say N.
[PATCH] Initial generic hypertransport interrupt support This patch implements two functions ht_create_irq and ht_destroy_irq for use by drivers. Several other functions are implemented as helpers for arch specific irq_chip handlers. The driver for the card I tested this on isn't yet ready to be merged. However this code is and hypertransport irqs are in use in a few other places in the kernel. Not that any of this will get merged before 2.6.19 Because the ipath-ht400 is slightly out of spec this code will need to be generalized to work there. I think all of the powerpc uses are for a plain interrupt controller in a chipset so support for native hypertransport devices is a little less interesting. However I think this is a half way decent model on how to separate arch specific and generic helper code, and I think this is a functional model of how to get the architecture dependencies out of the msi code. [akpm@osdl.org: Kconfig fix] Signed-off-by: Eric W. Biederman <ebiederm@xmission.com> Cc: Greg KH <greg@kroah.com> Cc: Andi Kleen <ak@muc.de> Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-10-04 02:16:55 -07:00
config HT_IRQ
bool "Interrupts on hypertransport devices"
default y
[PATCH] HT_IRQ must depend on PCI CONFIG_PCI=n, CONFIG_HT_IRQ=y results in the following compile error: ... LD vmlinux arch/i386/mach-generic/built-in.o: In function `apicid_to_node': summit.c:(.text+0x53): undefined reference to `apicid_2_node' arch/i386/kernel/built-in.o: In function `arch_setup_ht_irq': (.text+0xcf79): undefined reference to `write_ht_irq_low' arch/i386/kernel/built-in.o: In function `arch_setup_ht_irq': (.text+0xcf85): undefined reference to `write_ht_irq_high' arch/i386/kernel/built-in.o: In function `k7nops': alternative.c:(.data+0x1358): undefined reference to `mask_ht_irq' alternative.c:(.data+0x1360): undefined reference to `unmask_ht_irq' make[1]: *** [vmlinux] Error 1 Bug report by Jesper Juhl. Signed-off-by: Adrian Bunk <bunk@stusta.de> Cc: "Eric W. Biederman" <ebiederm@xmission.com> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-10-11 01:22:04 -07:00
depends on PCI && X86_LOCAL_APIC && X86_IO_APIC
[PATCH] Initial generic hypertransport interrupt support This patch implements two functions ht_create_irq and ht_destroy_irq for use by drivers. Several other functions are implemented as helpers for arch specific irq_chip handlers. The driver for the card I tested this on isn't yet ready to be merged. However this code is and hypertransport irqs are in use in a few other places in the kernel. Not that any of this will get merged before 2.6.19 Because the ipath-ht400 is slightly out of spec this code will need to be generalized to work there. I think all of the powerpc uses are for a plain interrupt controller in a chipset so support for native hypertransport devices is a little less interesting. However I think this is a half way decent model on how to separate arch specific and generic helper code, and I think this is a functional model of how to get the architecture dependencies out of the msi code. [akpm@osdl.org: Kconfig fix] Signed-off-by: Eric W. Biederman <ebiederm@xmission.com> Cc: Greg KH <greg@kroah.com> Cc: Andi Kleen <ak@muc.de> Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2006-10-04 02:16:55 -07:00
help
This allows native hypertransport devices to use interrupts.
If unsure say Y.
PCI: initialize and release SR-IOV capability If a device has the SR-IOV capability, initialize it (set the ARI Capable Hierarchy in the lowest numbered PF if necessary; calculate the System Page Size for the VF MMIO, probe the VF Offset, Stride and BARs). A lock for the VF bus allocation is also initialized if a PF is the lowest numbered PF. Reviewed-by: Matthew Wilcox <willy@linux.intel.com> Signed-off-by: Yu Zhao <yu.zhao@intel.com> Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
2009-03-19 20:25:11 -07:00
config PCI_IOV
bool "PCI IOV support"
depends on PCI
help
I/O Virtualization is a PCI feature supported by some devices
which allows them to create virtual devices which share their
physical resources.
If unsure, say N.
Copy Permalink